Converting A Commander Or Member To A Member Of Another Stack - HP ProCurve 5300xl Series Management Manual
Advanced traffic
Hide thumbs
Also See for ProCurve 5300xl Series:
- Access security manual (292 pages) ,
- Specification sheet (12 pages) ,
- Management and configuration manual (508 pages)
Table of Contents
Figure 13-17. The eXecute Command Displays the Console Main Menu for the
Selected Stack Member
2. You can now make configuration changes and/or view status data for the
selected Member in the same way that you would if you were directly
connected or telnetted into the switch.
3. When you are finished accessing the selected Member, do the following
to return to the Commander's Stack Access screen:
a.
Return to the Member's Main Menu.
b. Press
(for Logout), then
[0]
c.
Press
[Return]
.
You should now see the Commander's Stack Access screen. (For an
example, see figure 13-16 on page 13-22.)
Converting a Commander or Member to a Member of Another
Stack
When moving a commander, the following procedure returns the stack mem
bers to Candidate status (with Auto-Join set to "No") and converts the stack
Commander to a Member of another stack. When moving a member, the
procedure simply pulls a Member out of one stack and pushes it into another.
1.
From the Main Menu of the switch you want to move, select
9. Stacking
2.
To determine the MAC address of the destination Commander, select
2. Stacking Status (All)
Stack Management for the Series 3400cl and 6400cl Switches
(for Yes).
[Y]
Configuring Stack Management
Main Menu for stack
Member named "Coral Sea"
(SN = 1 from figure 13-16)
13-23
Hide quick links:
Table of Contents
Troubleshooting
