Mount The Module; Product Dimensions - Allen-Bradley 1732E ArmorBlock Series User Information

2-port ethernet/ip modules with quickconnect

Hide thumbs Also See for 1732E ArmorBlock Series:

Table of Contents

1732E ArmorBlock 2-Port EtherNet/IP Modules with QuickConnect

Set Network Address

Example shows default

node address set at 163.

When the switches are set to a valid number, the I/O block's IP address is 192.168.1.xxx

(where xxx represents the number set on the switches). The I/O block's subnet mask is

255.255.255.0 and the gateway address is set to 0.0.0.0. When the I/O block uses the

network address set on the switches, the I/O block does not have a host name assigned to it

or use any Domain Name Server.

If the switches are set to an invalid number (for example, 000 or a value greater than 254

excluding 888), the I/O block checks to see if DHCP is enabled. If DHCP is enabled, the

I/O block asks for an address from a DHCP server. The DHCP server also assigns other

Transport Control Protocol (TCP) parameters.

If DHCP is not enabled, the I/O block uses the IP address (along with other TCP

configurable parameters) stored in nonvolatile memory.

Mount the Module

Two sets of mounting holes are used to mount the module directly to a panel or machine.

Mounting holes accommodate #8 (M4) pan head screws. The torque specification is

1.13 Nm (10 in-lb).

Refer to the mounting dimensions illustration to help you mount the module.

Publication 1732E-IN010C-EN-E - June 2013

45759

Table of Contents