Table of Contents
VSF Status
Uptime
VSF MAD
VSF Port Speed
Software Version : WC.16.03.0000x
Mbr
ID
MAC Address
--- ------------- -------------------------------------- --- ---------------
*1
b05ada-961100 Aruba JL253A 2930F-24G-4SFP+ Switch
2
b05ada-9721c0 Aruba JL260A 2930F-48G-4SFP Switch
3
b05ada-972200 Aruba JL254A 2930F-48G-4SFP+ Switch
Enter the following commands on device 4:
Switch# configure
Switch(config)# vsf member 4 priority 100
Switch(config)# vsf member 4 link 1 49-52
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 4 link 2 21-24
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf enable domain 5472
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
The above sequence of commands will configure switch 4 as a Member, with a priority 100. Connect links
between switch 3 and switch 4, and switch 4 and switch 1, after executing the vsf enable domain
command on switch 4. A 4-member stack will now be formed with four ports bundled in a single VSF link.
Switch# show vsf
VSF Domain ID
MAC Address
VSF Topology
VSF Status
Uptime
VSF MAD
VSF Port Speed
Software Version : WC.16.03.0000x
Mbr
ID
MAC Address
--- ------------- -------------------------------------- --- ---------------
*1
b05ada-961100 Aruba JL253A 2930F-24G-4SFP+ Switch
2
b05ada-9721c0 Aruba JL260A 2930F-48G-4SFP Switch
3
b05ada-972200 Aruba JL254A 2930F-48G-4SFP+ Switch
4
b05ada-96f080 Aruba JL259A 2930F-24G-4SFP Switch
4. The show vsf link command will display an output of VSF port state and links for each VSF member.
Automatic configuration of a VSF fabric
Automatic configuration of a VSF is simpler than the manual configuration, as it only requires the user to log in
and configure one switch. The other switches automatically get their configurations from the first switch, but only if
the switches are in factory default state. Automatic configuration is not supported on switches that have been
previously deployed, or have had any configuration change made to them, over either CLI, web, or SNMP. A
switch may be restored to factory default state by using the CLI command erase startup-configuration
command.
Chapter 20 Virtual Switching Framework (VSF)
: Active
: 0d 3h 22m
: None
: 1G
Model
: 5472
: b05ada-961103
: Ring
: Active
: 0d 3h 22m
: None
: 1G
Model
Pri Status
200 Commander
150 Standby
100 Member
Pri Status
200 Commander
150 Standby
100 Member
100 Member
695
Table of Contents
Troubleshooting
