Using CPSW
This chapter describes how to configure Model 4010 dispatch consoles. This is
accomplished through three primary tasks:
1. Use one of the following methods to get configuration settings:
a. Download an existing configuration from a console
(see
b. Open an existing configuration file from a disk
(see
c. Start with a new, blank configuration
(see
2. Edit the configuration settings as needed
(see
Editing a Configuration
3. Save the configuration file and send the configuration to one or more consoles
(see
Sending a Configuration to a Console
This section,
need to do in order to configure your consoles.
Starting CPSW
Start CPSW by double-clicking on its shortcut. Alternatively, the program itself is located
in C:\Program Files\Zetron\CPSW\ and titled "CPSW_Application.exe" (assuming the
default location was used during installation). If you don't use the shortcut, CPSW will
prompt you for the system type, which is M4010.
Configuring CPSW
The serial port setting is the only setting needed to configure the CPSW application. By
default, CPSW is set to COM1.
♦
To configure the serial port
1. Determine which serial port will be used to connect to consoles (typically COM1
or COM2).
2. Go to Communication, Set Serial Port.
3. CPSW provides a list of available COM ports. Select the serial port to use.
4. Click Save Port Selection.
Loading a Configuration
Zetron uses CPSW to preconfigure Model 4010 consoles for customers. The resulting
configuration file is supplied by email or floppy disk to customers.
To receive the configuration from a console
To load a configuration from a file
To configure a position's panel layout
on page 85)
Using
CPSW, provides step-by-step procedures to cover everything you
CPSW Menu Structure
on page 84)
on page 84)
on page 94)
on page 101)
83