Configuration On - ZETRON 4010 Installation And Programming
Radio dispatch console
Hide thumbs
Also See for 4010:
- Service manual (123 pages) ,
- Spec sheet (4 pages) ,
- Programming manual (117 pages)
Table of Contents
Auxiliary Input Port numbers 9-38 are assigned to the optional Expanded Aux. I/O
Card(s) (P/N 702-9448) as follows: 9-14 to the first Aux. I/O Card, 15-20 to the second
Aux. I/O Card, etc. This allows the Model 4010 to support up to five Aux. I/O Cards for a
total of 30 ports. Auxiliary Output Port numbers 9-38 are assigned to the optional
Expanded Aux. I/O Card(s) in the same manner as the input ports as described above.
Auxiliary Input Port numbers 1-8 are assigned to the Model 4010 main PC board Spare/
Aux. inputs (on connector P8) if these inputs have been configured as auxiliary inputs. If
the inputs have been defined as spare inputs instead (the default), Auxiliary Input Port
numbers 1-8 are unavailable. Auxiliary Output Port numbers 1-8 are assigned to the
Model 4010 main PC board Spare/Aux. outputs (on connector P7) if these outputs have
been configured as auxiliary outputs. If the outputs have been defined as spare outputs
instead (the default), Auxiliary Output Port numbers 1-8 are unavailable. In this case,
however, spare outputs can be assigned to a key (see
Note
Note
Selecting Auxiliary Input / Output Functions will display the AUXILIARY INPUT /
OUTPUT menu. From the menu you may assign an auxiliary input, one of three different
types of auxiliary outputs, or spare outputs.
Outputs 7 and 8 in Reverse Selective Calling Mode
If either a primary or secondary ANI address is programmed (see
page 97), the console operates in Reverse Selective Calling (RSC) mode. Radios must
support one of the following signaling modes in order to support RSC: DTMF, 5/6 Tone,
or SS1A.
If a primary or secondary ANI address is programmed, and your radios support RSC, and
Spare Outputs 7 and 8 are not programmed, then Spare Outputs 7 and 8 will function as
follows:
• Spare Output 7: ON when ANI is displayed on the console display, OFF otherwise
• Spare Output 8: Produces a 500 ms pulse when an ANI is decoded by the console
Auxiliary Input
By assigning an input to this key, the associated LEDs will reflect the state of the input.
Pick the desired inputs by entering the input numbers. The input must have been
previously enabled using the System Configuration menu (see
auxiliary inputs and outputs
Description of Key Functions and Parameters
Auxiliary Output Ports 1 through 4 are logic level outputs. Auxiliary
Output Ports 5 through 8 are relay closures.
For more information about spare and auxiliary inputs and outputs,
see
Input/Output Configuration
on page 92). Then select the desired LED behavior.
Key Definitions
on page 94).
on page 90.
ANI Decode/Display
To enable and name the
on
129
Table of Contents
