Troubleshooting; Specifications - Panasonic nanoe EH-HS99 Operating Instructions Manual

Problem

• Sparks are generated inside the nanoe™

Outlet.

• The nanoe™ Outlet emits a noise

(crackling noise).

When the temperature is set to [395] or [365]

it blinks alternately between 395 °F or 365 °F,

and 340 °F.

All temperature setting lamps keep blinking.

It takes time to reach operating

temperature.

If the problems still cannot be solved, contact the store where you purchased the unit or a service center authorized by Panasonic for repair.

100 - 120 V

Power source

50 - 60 Hz

Power consumption

160 - 220 W

The amount of power consumption is determined as the maximum input value measured during the preheat cycle at operation

temperature under full-load conditions.

This product is intended for household use only.

16

Possible cause

Dust, styling products, etc. are adhered

to the pin-shaped portion where

nanoe™ is generated.

It is on standby mode.

The time to reach operating temperature

(approximately 210 °F) differs

depending on the area.

100 - 120 V: about 30 seconds

220 - 240 V: about 30 seconds

220 - 240 V

50 - 60 Hz

190 - 220 W

Action

Clean the nanoe™ Outlet to

remove any adherents.

When resuming use, press

the [+] or [-] temperature

setting switches and return

the temperature setting to

395 °F or 365 °F.

Please request an inspection or

repair from place of purchase.