Related Manuals for Sony MDR-RF830RK
Summary of Contents for Sony MDR-RF830RK
- Page 1 3-864-094-11(1) Wireless Stereo Headphone System Operating Instructions MDR-RF830RK Sony Corporation © 1998 Printed in Korea...
-
Page 2: Table Of Contents
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Welcome! Thank you for purchasing the Sony MDR-RF830RK Wireless Stereo Headphone System. Before operating the unit, please read this manual thoroughly and retain it for future reference. -
Page 3: Unpacking
When you use the headphones with the supplied rechargeable batteries NC-AA-HJ for the first time, charge the batteries in the following manner. NC-AA-HJ is applicable only for Sony cordless/ wireless headphone systems. Never use for any other purpose. Press the OPEN button to open the battery compartment lid of the transmitter. - Page 4 If the indicator is not lit Check that the supplied rechargeable batteries are correctly inserted in the battery compartment of the transmitter. To recharge the headphones’ batteries after use To charge the batteries, follow steps above. Since little electric current is used for charging, there is no need to worry about overcharging.
-
Page 5: Setting Up The Headphones
Battery life Battery Approx. hours* Sony alkaline battery LR6 (SG) Sony battery R6P (SR) * at 1 kHz, 1 mW + 1 mW output Notes on batteries To avoid damage to the system caused by battery leakage and corrosion; – Install the batteries with the correct polarity. -
Page 6: Setting Up The Transmitter
Setting up the transmitter Connect the transmitter to audio/video equipment. Select one of the hookups below depending on the jack type: a To connect to a headphones jack Transmitter Right channel Left channel (red) (white) Connecting cord (supplied) Unimatch plug... - Page 7 • When you connect the connecting cord directly to an • If the connected equipment has the AVLS (Automatic Left channel (white) * WALKMAN is a registered trademark of Sony TV, etc. Connect the transmitter to an AC outlet using the supplied AC power adaptor.
-
Page 8: Listening To A Program
RF signals after detecting an audio signal. Note If the transmitter is connected to the headphones jack of the source equipment, set the volume of that equipment as high as possible without distorting the audio signal. Auto power on/off function When you remove the headphones, the power turns off automatically. -
Page 9: The Effective Areas Of The Transmitter
Holder Note Do not hang the headphones by the self adjusting band, otherwise, the self adjusting band will be pulled up and the headphones will be switched on. The effective areas of... -
Page 10: Replacing The Ear Pads
Replacing the ear pads When the ear pads become dirty or damaged, you can get replacements from your Sony dealer. Replace them as illustrated below. Remove the old ear pad by pulling it out of the groove on the housing. -
Page 11: Troubleshooting
Select the radio frequency with the CHANNEL selector, then tune the headphones in the frequency of the transmitter with the TUNING control. The mute function is activated. Use the headphones near the transmitter. -
Page 12: Specifications
The rechargeable batteries other than NC-AA-HJ are installed. • Install NC-AA-HJ rechargeable batteries. Incapable Turn up the volume moderately, then of the tuning tune in the frequency. Sony Corporation Printed in Korea Specifications General Carrier frequency 863.32 – 863.67 MHz Channel Ch1, Ch2...