Parameterization - Siemens SINUMERIK FM-NC Installation And Startup Manual
Hide thumbs
Also See for SINUMERIK FM-NC:
- Programming manual (598 pages) ,
- Programming manual (327 pages)
Table of Contents
10 Drive Optimization with Start-Up Tool
10.8 Trace function (SW 4.2 and higher)
10.8.3
Parameterization
Parameterization
in the basic
display
Signal selection
Input field
axis/spindle name
Input field
Signal selection
10-224
In the basic display you can select
S
The axis/spindle to be measured
S
The signal to be measured
S
The duration of measurement
S
The triggering time
S
The type of triggering
S
The triggering threshold
The cursor must be positioned on the "Axis/spindle name" list box of the trace
concerned. You can select it with the softkeys Axis+ and Axis– or by accepting
a value from the dropdown list.
The cursor must be on the "Signal selection" list box of the trace concerned.
You can select a value by accepting it from the dropdown list.
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
Siemens AG 2000 All Rights Reserved
05.98
03.96
Chapters
Table of Contents
