Table of Contents
Introduction and Operation CDT835S, PDF829S and PDT825S
Tub TCO
The dual wattage 4-pass Calrod Heater serves both to heat the water during a wash cycle, and to heat the
air during the dry cycle. Heat and air circulation are required for good dry performance. Air circulation is
forced air with a power dry fan. Air enters through the
seconds "on" for 28 minutes during a Normal cycle with no wash boost options selected. Boost wash options
will change the time needed due to hotter temperatures in rinse for the options and cycle selected. The table
below represents a normal cycle with a Heated Dry option only selected.
The Calrod Heating element is rated at 120 VAC.
Heater 120 VAC
Wet
Watts
793
Ohms
16.4
23.2
Amps
6.6
Dry System
Heated Dry Element Algorithm
4 Pass Heater Algorithm, Dry Cycle
Normal with Heated Dry
Time (minutes) Calrod Description
6
Calrod on
28
14
Normal with Temp Boost or Sani Selected
6
Calrod on
58
Dry
625
+/- 5%
+/- 5%
5.2
+/- 5%
Heater Supports
Heater Clip (on Main Conduit)
– 85 –
Heat Element
Gasket
Nut
(Continued next page)
- Quick Links:
- Troubleshooting
- Consumer Error Mode
- Service Mode
Hide quick links:
Table of Contents
