Table of Contents
This section of the guide provides details on segments of cycles, timing of cycles, temperature expectations
and cycling of the heater.
Auto Hot Start
If incoming water temperature is below 80°F, Auto Hot Start is initiated at the beginning of the cycle in an
attempt to purge the home water lines of cooler water. Auto Hot Start can add up to 10 minutes to overall
repeating this sequence if the 80°F temperature is not met. The dishwasher can repeat this up to 3 times if
of the cycle.
Cycle Times
Times will vary depending on options selected,
incoming water temperature (120°F - 140°F is
recommended), and soil level.
Rinse
15 minutes
Express
30 - 51 minutes
Light
54 - 104 minutes
eWash
62 - 212 minutes
Normal
77 - 181 minutes
Auto
111 - 201 minutes
Heavy
150 - 221 minutes
NOTE:
The above table is for exposed heater models.
power fan is in operation during Power Dry.
Operation and Cycle Information
Heated Dry Element Algorithm (Exposed Heater Models)
4 Pass Exposed Heater Algorithm, Dry Cycle
Normal with Heated Dry
Time (minutes) Calrod Description
6
Calrod on
28
14
Normal with Temp Boost or Sani Selected
6
Calrod on
58
The Cycle Times table considers soil level and dry
options. Times will vary depending on turbidity
response and incoming water temperature.
The Cycle Times table does NOT consider the below
•
Selecting the Wash Temp option(s) will add
up to 24 minutes to the cycle and increase
temperatures 5°F.
•
The Steam option adds a Pre-Wash segment to
increase temperature.
•
The Bottle Wash option will increase the cycle
time, adding up to 23 minutes; water usage
does not change.
•
The Sani option increases temperature of some
Circulations 5°F and changes Final Rinse to
Sanitizing Rinse with 153°F target.
– 10 –
- Quick Links:
- Troubleshooting
- Consumer Error Mode
- Service Mode
Hide quick links:
Table of Contents
