Honeywell Lyric RF6GB Installation Instructions

PLEASE GO TO THE LAST PAGE FOR FCC/IC

AGENCY STATEMENTS

The RF6GB is a wireless glassbreak detector intended for use with Honeywell controls that support SiX™

Series devices.

Mounting

The RF6GB can be mounted

on the wall or on the ceiling.

• within 7.6 m (25 feet) of the

protected glass;

• within clear view of the

protected glass;

• at least 2 m (6.5 feet) from the

floor;

• at least 1 m (3.3 feet) from

forced air ducts;

• at least 1 m (3.3 feet) from

sirens or bells greater than 5

cm (2 inches) in diameter.

• between the protected glass

and any heavy window

coverings.

• when heavy window coverings

are present, the detector can

be mounted on the window

frame.

• Avoid mounting the detector

on the same wall as the

protected glass, on free-

standing posts or pillars, or in

rooms with noisy equipment

(air compressors, bells, power

tools, etc.), if this equipment is

operated when the detector is

armed.

• UL requirements:

TBD

To remove the mounting bracket:

Turn the top of the detector 15 degrees

counter-clockwise and separate the

mounting bracket.

Note: Before mounting the RF6GB

permanently, conduct Go/No Go tests (see

control's instructions) to verify adequate

signal strength and adjust the device location

and orientation as necessary.

•

The RF6GB can be mounted on the wall

or on the ceiling.

•

The rear tamper plate MUST be mounted

to a stud, solid wood, or with a robust

wall anchor.

BETA DRAFT – 01/12/15