Table of Contents
RUGGEDCOM ROX II
CLI User Guide
show running-config ip interface ipv4
Where:
• interface is the name of the interface
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config ip ipv4 | tab
IFNAME
IPADDRESS
-------------------------------------
dummy0
1.1.1.1/32
fe-cm-1
192.168.0.12/24
172.30.150.12/19
switch.0001
switch.0011
192.168.11.1/24
switch.0012
192.168.12.1/24
switch.0014
192.168.14.1/24
If no addresses have been configured, add addresses as needed. For more information, refer to
"Adding an IPv4
Address".
Section 5.40.3.2
Adding an IPv4 Address
To add an IPv4 address to a routable interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the address by typing:
ip interface ipv4 address address
Where:
• interface is the name of the interface
• address is the IPv4 address
3.
Configure the following parameter(s) as required:
Parameter
peer { peer }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.40.3.3
Deleting an IPv4 Address
To delete an IPv4 address for a routable interface, do the following:
1.
Make sure the CLI is in Configuration mode.
Adding an IPv4 Address
PEER
-
-
-
-
-
-
Description
Synopsis: A string 7 to 15 characters long
The peer IPv4 Address (xxx.xxx.xxx.xxx, PPP, MLPPP,
FrameRelay link only).
Chapter 5
Setup and Configuration
Section 5.40.3.2,
593
Table of Contents
Troubleshooting
