Table 7-3:
Command
p
c
e
v
M
7.3.4
Console session navigation after boot complete
After typing bootChange in a console session, use the following commands to navigate:
Note
When modifying an entry, type the new setting. Do not attempt to backspace over an existing entry.
VxWorks commands are case-sensitive.
Table 7-4:
Key sequence
Enter
. (period)
– (dash)
safeReboot_vf
7.3.5
Boot flags
For the A6560R, you can list boot flags by typing a question mark (?) into in a console
session at the VxWorks boot prompt.
Boot flags below are expressed in hexadecimal. To activate more than one boot flag at the same
time, add them together using the Windows Calculator. Select View > Programmer, and select the Hex
radio button.
Table 7-5:
Boot Flag
0x0002
0x0004
0x0008
0x0040
MHM-97125-PBF-EN, R0
Console session navigation after boot interrupt
Description
Print boot parameters
Change boot parameters
Print fatal exception
Print version
Change MAC address
Console session navigation commands
Description
Accept the value.
Clear the value when you press the period key followed by Enter.
Go back to the previous parameter when you press dash followed
by Enter.
Reboot the system with new boot settings.
Complete list of boot flags
Description
Load local system symbols (for debug).
Don't autoboot (for testing).
Quick autoboot (no countdown).
Use DHCP to get IP address parameters (not recommended).
Hardware configuration
(continued)
65