Table of Contents
Hardware configuration
7.3
Configure the A6560R with a terminal
emulator
7.3.1
Configure a serial port connection from a computer
Use a terminal emulator such as Telnet or HyperTerminal to connect to the AMS Machinery
Health Monitor using a serial cable or an Ethernet cable.
Table 7-2
Prerequisites
You need a username and password to log on to a AMS Machinery Health Monitor with
Telnet.
Table 7-2:
Setting
serial port
baud rate
data bits
stop bit
parity
flow control
7.3.2
Configure A6560R boot parameters with a terminal
emulator
During normal usage, it is unlikely that you will need to change the initial boot parameters.
However, you may need to change boot settings in two situations:
•
•
Procedure
1.
(1) Telnet and HyperTerminal are Windows Features that are available but are not enabled by default. You can use other terminal emulator
programs.
62
in the terminal emulator's connection settings.
Serial port connection setup
If you replace the processor module. You may replace an A6560 with an A6560R.
The unit is added to an existing Ethernet network that is not directly connected to
the online server through a dedicated cable.
Note
Do not add a unit to an existing network until its processor board IP addresses have been
verified and changed, if necessary, to be compatible with addresses already in use on the
existing network.
Start a terminal session, and turn the unit on.
(1)
Configure the settings in
Value
COM1
9600
8
1
none
none
MHM-97125-PBF-EN, R0
Hide quick links:
Table of Contents
