Table of Contents
Quick Links
Light Source
Please read this manual fully before installing, operating or performing
Issue 3 | Revised: 260418
User Guide
MicroLED 100PD V2
Models covered by this manual:
UFO MIC100PT-3
UFO MIC100PT-4
UFO MIC100PT-6
UFO MIC100PC-3
UFO MIC100PC-4
UFO MIC100PC-6
UFO MIC100PCT-3
UFO MIC100PCT-4
UFO MIC100PCT-6
maintenance on the light source unit.
Light Source
Universal Fibre Optics
Home Place | Coldstream | TD12 4DT | United Kingdom
Tel: +44 (0)1890 883416 | Fax: +44 (0)1890 883062
www.fibreopticlighting.com
Table of Contents
Related Manuals for UFO MIC100PT-3
Summary of Contents for UFO MIC100PT-3
- Page 1 Light Source User Guide MicroLED 100PD V2 Light Source Models covered by this manual: UFO MIC100PT-3 UFO MIC100PT-4 UFO MIC100PT-6 UFO MIC100PC-3 UFO MIC100PC-4 UFO MIC100PC-6 UFO MIC100PCT-3 UFO MIC100PCT-4 UFO MIC100PCT-6 Please read this manual fully before installing, operating or performing maintenance on the light source unit.
- Page 2 Please read these instructions fully before connecting your unit to the electrical supply, and keep them for future reference. The UFO MIC100PD utilises a white light array with twinkle wheel and is suitable for use with either glass or polymer fibre-optic harnesses.
- Page 3 INSTALLATION INSTRUCTIONS POWER SUPPLY REQUIREMENTS This luminaire is powered by a 12V Power Supply Unit or 12V Constant Voltage Driver. Remove the PSU/driver from its box. The driver caters for UK/European/other mains supplies using the relevant power cord supplied. Connect the jack plug into the socket in the back, and the light source is now ready for connection.
- Page 4 MOUNTING If using the metal mounting plate proceed as follows: STEP 1 Remove the rubber feet from the bottom of the Light Source STEP 2 Push fit three of the expansion fittings into the holes vacated by the feet as shown – DO NOT fit an expansion fitting into the foot hole at the rear below the push buttons STEP 3 Place the mounting plate on the base as shown and push the remaining expansion...
-
Page 5: Operation
OPERATION This is a standalone static twinkle white light unit. Once setup according to the connection instructions the unit is ready for use. The unit has two control push buttons on the rear. These buttons are push and release momentary action type. Upper button: controls motor speed Lower button: controls dimming MAINTENANCE... -
Page 6: Troubleshooting
TROUBLESHOOTING Problem Probable cause(s) Remedy Mains supply off Check supply and reinstate Unit is dead - LED power indicator is not Loose mains plugs Check plugs illuminated PSU failed Replace PSU Unit is dead - no light output but LED power LED array failure Replace LED unit indicator is still... -
Page 7: Technical Specifications
TECHNICAL SPECIFICATIONS Description Details Port connector size 30mm Glass/Polymer Fibre type 200-240V 50/60Hz (range dependant on PSU/driver) Supply voltage PSU Output 12V DC 12W minimum LED Power Min Ambient Temperature -10ºC Max Ambient Temperature +45ºC 2.1 x 5.5 x 12mm Power Connection LED Type / Model White Light with decorative wheel... - Page 8 Universal Fibre Optics Home Place | Coldstream | TD12 4DT | United Kingdom Tel: +44 (0)1890 883416 | Fax: +44 (0)1890 883062 www.fibreopticlighting.com...