Table of Contents
Available languages
Available languages
Installation Instructions
Where to install the Transmitters
Installing the Transmitters
Since the unit is factory programmed, calibrated and completely
wireless, installation simply requires the physical mounting of the
enclosure.
Once you have selected locations for all the transmitters of your
network, temporarily affix them to their assigned places until you are
certain that their placement is appropriate and that transmitters and
communication are functioning. You can then permanently install the
units. Remove the cover on the 301W (to access the mounting holes).
Mark the holes, as shown:
•
Height markers 22.5cm (8.85") apart
•
Pre-drill mounting holes as needed
•
Securely mount the 301W using the appropriate screws
•
Replace the unit's cover
16
Ceiling/Plafond
Ground / sol
301W User Manual
Honeywell
NO
2
30 cm (12")
22.5 cm
8.85"
CO
1.5m (5')
511398
5/07
Chapters
Table of Contents
