NEC UNIVERGE SV9100 Configuration Manual page 23

Issue 1.0

14

10-29-01 : SIP Server Information Setup – Outbound Default Proxy

Enable (1) the SIP Outbound Proxy.

If entries are made in Program 10-29-xx for a SIP Server and the SIP Server is then removed

.

or not used, the entries in Program 10-29-xx must be set back to their default settings. Even

if 10-29-01 is set to .0. (off), the SV9100 will check the settings in the remaining 10-29

programs.

10-29-03 : SIP Server Information Setup – Default Proxy IP Address

Define the SIP Trunk Service Provider Proxy IP Address. You may resolve the IP

address of the Outbound Proxy by pinging the URL.

10-29-5 : SIP Server Information Setup – Registrar Mode

Set the Registrar Mode to 1 (Manual) with SIP trunking.

10-29-6 : SIP Server Information Setup – Registrar IP Address

Input the IP address of the SIP registrar (if given).

10-29-11 : SIP Server Information Setup – SIP Proxy Setup – Registrar

Domain Name

Define the Registrar Domain Name. This information should be provided by your

SIP service provider (128 characters maximum).

10-29-12 : SIP Server Information Setup – Proxy Domain Name

Enter the Domain name.

When configuring the Domain name, the SIP service provider will supply the Proxy/

.

Domain in the following manner - "Host Name" . "Domain Name" . The characters are

normally separated by "." The characters after "." will be in the Domain Name.

10-29-13 : SIP Server Information Setup – Proxy Host Name

Enter the Host name.

When configuring Domain name the SIP service provider will supply the Proxy/Domain in

.

the following manner - "Host Name" . "Domain Name" . The characters are normally

separated by "." The characters before "." will be in the Host Name.

10-29-14 : SIP Server Information Setup – SIP Carrier Choice

Set the SIP Carrier Choice to 2 (Carrier B).

This setting is not applicable for this carrier test.

.

10-29-15 : SIP Server Information Setup – Registration Expiry Time

It is important to leave this automatic re-registration time to be 3600 seconds so

that the IDT/Net2Phone network does not get flooded.

10-29-16 : SIP Server Information Setup – Register Sub Mode

Unchecking the Register Sub Mode (setting it to "off") will allow all trunk calls to be

routed based on routing policies.

10-29-21 : SIP Server Information Setup – NAT Router

Disable this Program (NAT Router is not used for this testing).

SIP Trunking Service Configuration Guide

IDT/Net2Phone