Configuring The Tftp Server And Bootfile Name For The Client - HP 10500 Series Configuration Manual
Layer 3 - ip services
Hide thumbs
Also See for 10500 Series:
- Security configuration manual (596 pages) ,
- Configuration manual (512 pages) ,
- Specifications (42 pages)
Table of Contents
To configure option 184 parameters in a DHCP address pool:
Step
1.
Enter system view.
2.
Enter DHCP address pool view.
3.
Specify the IP address of the
primary
processor.
4.
Specify the IP address of the
backup
processor.
5.
Configure the voice VLAN.
6.
Specify the failover IP address
and dialer string.
Configuring the TFTP server and bootfile name for the client
For the DHCP server to support client auto-configuration, specify the IP address or name of a TFTP server
and the bootfile name in the DHCP address pool. You do not need to perform any configuration on the
DHCP client.
The DHCP client obtains these parameters from the DHCP server, and uses them to contact the TFTP
server to request the configuration file used for system initialization.
When a router starts up without loading any configuration file, the system sets an active interface
1.
(such as the interface of the default VLAN or a Layer 3 Ethernet interface) as the DHCP client to
request from the DHCP server for parameters, such as an IP address and name of a TFTP server,
and the bootfile name.
After receiving related parameters, the DHCP client sends a TFTP request to obtain the
2.
configuration file from the specified TFTP server for system initialization. If the client cannot get
such parameters, it performs system initialization without loading any configuration file.
To configure the IP address and name of the TFTP server and the bootfile name in the DHCP address
pool:
Step
1.
Enter system view.
2.
Enter DHCP address pool
view.
Command
system-view
dhcp server ip-pool pool-name
[ extended ]
network
calling
voice-config ncp-ip ip-address
network
calling
voice-config as-ip ip-address
voice-config voice-vlan vlan-id
{ disable | enable }
voice-config fail-over
ip-address dialer-string
Command
system-view
dhcp server ip-pool pool-name
[ extended ]
44
Remarks
N/A
N/A
Not primary network calling
processor is specified by default.
After you configure this command,
the other Option 184 parameters
take effect.
Optional.
No backup network calling
processor is specified by default.
Optional.
No voice VLAN is configured by
default.
Optional.
No failover IP address or dialer
string is specified by default.
Remarks
N/A
N/A
Table of Contents
Troubleshooting
