Emc Class A Notices And Warnings (Us And Canada); Class A Notice For Fcc; Class A Notice For Canada - Cisco 1120 Hardware Installation
Connected grid router
Hide thumbs
Also See for 1120:
- Installation manual (164 pages) ,
- Quick start manual (10 pages) ,
- Manual (6 pages)
Table of Contents
AC power cable that meets the following requirements:
—
Wiring compatible with the power supply used at your site: single-phase or three-phase, rated 10A minimum
—
Plug that is compatible with the power source used at your site: single-phase or three-phase.
—
Correct length for your installation
DC power cable that meets the following requirements:
—
The length and gauge of the DC power cable must be selected such that the voltage supplied to the terminals
of the router does not drop below 10.6VDC, which is the minimum recommended operating voltage. See the
Power Specifications section in the Router Hardware Description chapter.
—
The maximum input current at 9VDC input will be less than 7A and the wire size must be selected by considering
the installation DC operating voltage. DC input on the router accommodates a 12AWG to 18AWG wire size.
—
Please consult your Cisco reseller, partner, or sales representative for unusual installation requirements of
greater than 30 feet of cabling.
EMC Class A Notices and Warnings (US and Canada)
Tip:
For a complete listing of all EMC Class A Notices and Warnings, refer to following document:
Regulatory Compliance and Safety Information for the Cisco 1000 Series Connected Grid Routers
Class A Notice for FCC, page 46
Class A Notice for Canada, page 46
Class A Notice for FCC
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying with FCC
requirements for Class A digital devices. In that event, your right to use the equipment may be limited by FCC regulations,
and you may be required to correct any interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
users will be required to correct the interference at their own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Class A Notice for Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada (IC) license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
46
Chapters
Table of Contents
