Table of Contents
4 Disassembly and Assembly Instructions
Important notice: Before replacing any components, make sure to turn OFF the vacuum cleaner.
Remove the power plug from the outlet.
* Caution:
1. Do not attempt to modify the machine, parts, etc. when marking repairs.
2. Even if a wire is partially disconnected, do not attempt to repair and/or connect it when a wired unit is available as
service parts. Replace the overall section with a new wired unit.
3. Pull out and/or insert the fastening terminal without twisting it.
4.1.
Dust
box
removal
1. Open the dust box cover assembly at an angle of approx.
45°. Insert a flat-blade screwdriver between the upper
body and the dust box cover assembly and move it in the
direction of the arrow mark to remove the dust box cover
assembly from its right side.
cover
assembly
4.2.
Separate the upper and lower
body units
1. Remove the five screws fixing the upper body U and
lower body U.
2. Remove the screw fixing the upper body U from the rear
side.
6
Table of Contents
