Switching Off The Projector - Panasonic PT-VZ580 Operating Instructions (Functional Manual)

2)

Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the

installation mode. (

f Refer to "Navigating through the menu" (

3)

Press the input selection buttons on the remote control or the button on the control

panel to select the input signal. (

f The buttons that can be used on the remote control are as follows.

button

4)

Adjust the front, back and sideway tilt of the projector with the adjustable feet. (

5)

Adjust the size of the image to match the screen with the zoom lever.

6)

Adjust the vertical projection position with the vertical lens shift dial.

7)

If the input signal is an analog RGB signal, press the button.

8)

Adjust the focus again with the focus lever.

9)

Adjust the size of the image to match the screen with the zoom lever again.

Note

f When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed, the

[INITIAL SETTING] screen is displayed after projection starts. Refer to "When the initial setting screen is displayed" (

1)

Press the power button.

f The [POWER OFF] confirmation screen is displayed.

2)

Press qw to select [OK], and press the button.

(Or press the power button again.)

f Projection of the image will stop, and the power indicator on the projector lights in

orange. (The fans keep running.)

3)

Wait until the power indicator on the projector lights or blinks in red.

f The projector enters standby mode when the power indicator lights or blinks in red.

4)

Disconnect the plug of the power cord from the outlet.

Note

f While the power indicator is lighting in orange, the luminous lamp is being cooled down and the projector cannot be

turned on. Wait until the power indicator starts lighting or blinking in red to turn on the projector again.

f Even if the power is turned off by pressing the power button, the projector consumes power if the power plug is connected

to the outlet.

When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is

restricted, but the power consumption during standby can be conserved.

Chapter 3 Basic Operations - Switching on/off the projector

page 26)

Æ

Æ

page 41)

Æ

3)

1)

page 50) for the operation of the menu screen.

1)

2)

2)

Æ

page 43)

page 37).

Æ

ENGLISH - 39