Table of Contents
Virtual IP address:
1.1.1.100
Authentication: (none)
Dell#
Tracking states for 2 resource Ids:
2 - Up IPv6 route, 2040::/64, priority-cost 20, 00:02:11
3 - Up IPv6 route, 2050::/64, priority-cost 30, 00:02:11
The following example shows verifying the VRRP configuration on an interface.
Dell#show running-config interface tengigabitethernet 1/8/1
interface TenGigabitEthernet 1/8/1
no ip address
ipv6 address 2007::30/64
vrrp-ipv6-group 1
track 2 priority-cost 20
track 3 priority-cost 30
virtual-address 2007::1
virtual-address fe80::1
no shutdown
Sample Configurations
Before you set up VRRP, review the following sample configurations.
VRRP for an IPv4 Configuration
The following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive
directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste
from the example to your CLI. To support your own IP addresses, interfaces, names, and so on, be sure that
Virtual Router Redundancy Protocol (VRRP)
1230
Table of Contents
Troubleshooting
