GE UR F35 Series Instruction Manual page 22
Multiple feeder protection
system
Hide thumbs
Also See for UR F35 Series:
- Instruction manual (526 pages) ,
- Instruction manual (616 pages) ,
- Instruction manual (640 pages)
Table of Contents
1.3 ENERVISTA UR SETUP SOFTWARE
3.
Select the Internet Protocol (TCP/IP) item from the list, and click the Properties button.
1
4.
Click the "Use the following IP address" box.
5.
Enter an IP address with the first three numbers the same as the IP address of the F35 relay and the last number dif-
ferent (in this example, 1.1.1.2).
6.
Enter a subnet mask equal to the one set in the F35 (in this example, 255.0.0.0).
7.
Click the OK button to save the values.
Before continuing, test the Ethernet connection.
1.
Open a Windows console window by selecting Start > Run from the Windows Start menu and typing "cmd".
2.
Type the following command, substituting the IP address of 1.1.1.1 with yours:
C:\WINNT>ping 1.1.1.1
3.
If the connection is successful, the system returns four replies similar to the following:
Pinging 1.1.1.1 with 32 bytes of data:
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Ping statistics for 1.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip time in milliseconds:
Minimum = 0ms, Maximum = 0ms, Average = 0 ms
4.
Note that the values for
5.
If the following sequence of messages appears when entering the
1-12
and
vary depending on local network configuration.
time
TTL
F35 Multiple Feeder Protection System
1 GETTING STARTED
command:
C:\WINNT>ping 1.1.1.1
GE Multilin
Table of Contents
