Christie DLV1400-DX User Manual page 60
Hide thumbs
Also See for DLV1400-DX:
- Instruction sheet (6 pages) ,
- Specifications (2 pages) ,
- User manual (178 pages)
Table of Contents
Section 3: Operation
3-34
Downloaded From projector-manual.com Christie Manuals
Simulation 3D —
SUBMENU OF ADVANCED IMAGE SETTINGS
Use the options in the Simulation 3D
menu to make the timing adjustments
necessary for realistic simulation and
3D images.
NOTES: 1) Available in Mirage
projectors only. 2) For complete 3D
application notes, refer to the
separate Using 3D in Mirage manual
provided with the Mirage projector.
FRAME DELAY MONITOR —
output. For best results, the bar width and value should remain fairly constant,
indicating that timing of input and output frames is locked; the Frame Delay Monitor
value should stay within 5-10 lines or so of the Frame Delay setting. If a frame is lost
or "dropped", the bar will move suddenly and the values will change, indicating that
the frame input is no longer equal to the output.
NOTE: See separate Using 3D in Mirage manual provided for more information.
Set the number of lines delayed between the input signal and its
FRAME DELAY —
appearance on screen, keeping in mind that projector processing always adds one
frame of delay to the frame delay setting. For applications such as simulation, where
the feeling of "real time" image response is a priority, a minimum setting is usually
preferable. For projectors capable of 3D (stereographic) applications where alternating
left-right frames must be synchronized with the corresponding L/R shutters in 3D
glasses, a total frame delay setting of two (or multiple of two) may be more useful. If
set too high or low, frame locking will not be possible—most sources require
approximately 50 lines of delay to ensure frame locking.
NOTE: See separate Using 3D in Mirage manual provided for more information.
Adjust Dark Interval to artificially increase the amount of dark
DARK INTERVAL —
time between displayed frames for stereographic 3D images. Higher settings provide
more time for shutters in 3D glasses to open/close, ensuring that each eye sees the full
display intended for it. Symptoms of cross talk and/or color artifacts can indicate need
for adjustment. The Dark Interval range of adjustment depends on the vertical
frequency of your source—the higher the frequency, the smaller the range.
NOTE: See separate Using 3D in Mirage manual provided for more information.
3D STEREO SYNC LOCKING —
stereographic 3D signal locks to the vertical sync output so that signals are
synchronized, and 2) whether or not the 3D frames must be inverted, i.e. swapped left-
with-right. The correct setting ensures that the projector's 3D display of left/right
frames is synchronized with the rest of the 3D system components so that the intended
eye sees the left/right image data. Select the option corresponding to your 3D source
connections and timing, and use only if the Mirage 3D Stereo Sync Cable is connected
between the projector's GPIO port and a server. Keep this adjustment OFF (default)
when you are not using the Mirage 3D Stereo Sync Cable.
This slide bar monitors the latency between input and
This option defines 1) whether or not the incoming
013-100199-03
Table of Contents
