Table of Contents
D01. Electronics
The purpose of this test is to verify the operation of the:
Electronics Module.
D
Hard Disk.
D
Line Sensor (only presence).
D
Trailing Cable.
D
Carriage Assembly.
D
This test does not test the MIO Card. For testing the MIO Card, refer to
the MIO Presence test ' page 4 21.
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE
REPLACING THE ELECTRONICS MODULE, TRAILING CABLE,
HARD DISK OR THE CARRIAGE ASSEMBLY. IF THIS TEST
PASSES, DO NOT REPLACE THE ELECTRONICS MODULE,
TRAILING CABLE, LINE SENSOR OR THE CARRIAGE ASSEMBLY.
Perform the Electronics test as follows:
1 In the Diagnostics submenu, scroll to D01 Electronics" and press Enter.
Diagnostics
D01 Electronics
2 The test will start and a row of ***" will be displayed on the front panel.
3 After a short while the message Access Printheads / Continue" will be
displayed on the front panel. Open the window and reseat all the Printheads.
Press the Down Arrow when you have reseated the Printheads.
4 The test will continue and a row of ***" will be displayed on the
front panel.
5 If the test passes, the D0100 OK" message is displayed on the front panel.
IF THIS TEST PASSES, DO NOT REPLACE THE ELECTRONICS
MODULE, TRAILING CABLE, HARD DISK OR THE CARRIAGE.
6 If the test fails, an error message will be displayed on the front panel. The
error messages are split into different areas depending on which
component failed.
The test is continued on the next page.
4-6
HP DesignJet CP Series Printers
Service Tests
Table of Contents
Troubleshooting
