Table of Contents
Encoder Strip
Refer to figures 10 and 11 ' pages 8 34 and 8 35
Removal
Switch off the printer and remove the power cord.
1. Remove the following:
1. Window and Top Cover ' page 8 15.
2. Right Hand Cover ' page 8 21.
3. Left Hand Cover ' page 8 18.
Care should be taken while performing the following
procedure, the encoder strip has sharp edges and
Caution: To prevent damage to the encoder strip, hold it at the
ends only.
Caution: Lay the encoder strip down on a flat surface when
not installed in the printer.
2. Remove the encoder strip roof over the carriage by squeezing it slightly.
3. Cut the cable tie which secures the magnetic core (item 1) to the encoder
grounding (item 12).
4. Remove two T 15 screws (item 2) securing the grounding bridge (item 3)
to the Y axis motor assembly (item 4).
Note: Working from the rear of the printer.
5. Remove the T 15 screw (item 5) securing the left side of the encoder strip
(item 7).
6. Release the encoder strip from the retaining pin (item 6) on the Y axis
tensioner holder (item 8). It may help to pull the encoder spring (item 9)
towards the middle of the printer to release some tension.
7. Remove the encoder spring (item 9) from the Y axis motor assembly by
releasing it from a retaining pin (item 10).
8. Remove the two nuts and two washers (items 11) securing the encoder
spring to the encoder grounding (item 12).
8-32
HP DesignJet CP Series Printers
WARNING
WARNING
could cause injury.
Removal and Installation
Table of Contents
Troubleshooting
