Table of Contents
Available languages
Available languages
Leave the appliance to charge for at
u
least 24 hours.
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
Important! Place the appliance on the
charging base whenever it is not in use.
Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Operating the appliance (fig. E)
To switch on, slide the on/off switch (1)
u
forward.
To switch off, slide the on/off switch
u
back.
Accessories (fig. B & C)
V1250/V4810/V4820/V7210/V9650
These models are supplied with the
following accessories:
a hard brush (6) for furniture and
u
stairs (not for V4820)
a crevice tool (7) for confined spaces
u
a soft brush (8) for keyboards and
u
lamp shades (V4820)
V1250/V9650
Two additional accessories are stored in
a portable caddy located in the charging
base:
a soft brush (8) for keyboards and
u
lamp shades
an extendable crevice tool (9) for
u
longer reach in confined spaces
V1250N
This model is not supplied with accessories.
To fit an accessory, proceed as follows:
Take the accessories from the
u
appliance.
Insert the appropriate accessory into
u
the front of the appliance.
ENGLISH
Cleaning and maintenance
Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. F & G)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and
u
remove the dust bowl (3).
Empty the dust bowl.
u
Remove the filters (10) by twisting
u
them clockwise.
Brush any loose dust off the filters.
u
Wash the filters in warm, soapy
u
water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
Make sure the dust bowl and filters
u
are dry.
Refit the filters (10) onto the appliance,
u
twisting them counterclockwise until
they lock into place.
Refit the dust bowl onto the appliance.
u
Make sure the dust bowl clicks into
place.
Warning! Never use the appliance without
the filters. Optimum dust collection will
only be achieved with clean filters and an
empty dust bowl.
Replacing the filters
The filters should be replaced every 6 to 9
months and whenever worn or damaged.
Replacement filters are available from
your Black & Decker dealer (catalogue
number: VF20).
Remove the old filters as described
u
above.
Fit the new filters as described above.
u
Maintenance
Your tool has been designed to operate
over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any
maintenance, switch off and unplug the tool.
7
Hide quick links:
Table of Contents
