Table of Contents
4E-33 ABS:
Rear Wheel Speed Sensor Removal and
Installation
Removal
1) Disconnect negative (–) cable from battery.
2) Remove quarter inner trim to brake referring to
"Floor Carpet Removal and Installation in Section
9H".
3) Turn over floor carpet (2) and disconnect connector
(1) of wheel speed sensor.
1
2
4) Hoist vehicle and remove wheel.
5) Remove harness clamp (1) and clamp bolts (2).
6) Remove rear wheel speed sensor (3) from knuckle.
CAUTION
!
• Do not pull wire harness when removing
rear wheel speed sensor.
• Do not cause damage to surface of rear
wheel speed sensor and do not allow dust,
etc. enter its installation hole.
S7RS0B4506008
2
I6RS0B460035-02
1
2
3
I6RS0B460036-02
Installation
Reverse removal procedure for installation noting the
following.
• Check that no foreign material is attached to sensor
(1) and mating encoder (2).
• Be sure to install wheel speed sensor (1) and its bolt
at the correct position as shown in figure.
Tighten sensor bolt and harness clamp bolts to
specified torque.
Tightening torque
Rear wheel speed sensor bolt (a): 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
Rear wheel speed sensor harness clamp bolt (a):
11 N·m (1.1 kgf-m, 8.0 lb-ft)
CAUTION
!
Do not pull or twist wire harness more than
necessary when installing rear wheel speed
sensor.
• Check that there is no clearance between sensor and
brake back plate.
[A]
1
[A]: OK
(b)
(a)
1
2
[B]
1
I6RS0B460037-02
[B]: NG
Hide quick links:
Chapters
Table of Contents
