Page 1
How to use your HITACHI VACUUM CLEANER MODEL CV-S950, CV-S960, CV-T940 日立吸塵器使用說明 型號 : CV-S950, CV-S960, CV-T940 wýU²O¼ s WOzUÐdNJë W MJ*« ‰ULF²Ý« WOHO q¹œu*« CV-S950, CV-S960, CV-T940 15/10/03, 3:02 PM 01/CV-S950_Cover(CS)
HOW TO OPERATE TO ASSEMBLE HOSE The hose and joint pipes are packed individually. To put them together, insert the curved joint pipe 1 and joint pipe 2 into each end of the hose 3 until the claws 4 of the stopper ring 5 click into the holes 6 of the curved joint pipe and joint pipe.
Page 4
TO ATTACH EXTENSION PIPES (CV-S950), (CV-T940) Attach the extension pipes 9 together by joining the two ends and twist a little to make it tight. 連接延長管 (CV-S950),(CV-T940) 將延長管9的兩端連接在一起,然後轉動一下, 使它們緊密連接。 Fig. 4 Extension pipes q¹uD² « VOÐU½« qO uð WOHO 圖4 連接延長管...
ON/OFF SWITCH Å Motor is switched ON/OFF by changing the power switch 開機/關機 Å Å 通過電源開關 ,可以啟動或關閉馬達。 ·UI¹ô«ØqOGA² « ÕU²HÄ Fig. 6 ON/OFF switch WOzUÐdNJ « W MJ*« „d×Ä ·UI¹«Ë qOGAð r²¹ 圖6 開機/關機 ON/OFF Å Æ WOzUÐdNJ « WÁUD « ÕU²HÄ dOOGð WDÝ«uÐ ·UI¹ô«ØqOGA²...
Page 6
RUG AND FLOOR TOOL (Deluxe) The nozzle is fitted with a brush at the back which can either be in the “withdrawn” or “projected” position. These positions are operated by the pedal on the ” (Carpet) # and “ tool marked “ ”...
DUST INDICATOR When the orange sign % appears in the large window continuously, the cleaner requires emptying. Check the dust indicator by lifting suction tool from the floor and removing the crevice nozzle when it is used. NOTE: If the cleaner is used when the orange sign appears in the large window, air to the motor will be reduced and the motor will eventually burn out.
Page 8
BLOWER Use your vacuum cleaner as a blower for hard to reach areas. 1. Insert the joint pipe 2 of the hose into the blower outlet ( until it snaps into place. 2. To remove the hose, press the button 8 and pull the hose from the cleaner.
Page 9
TO DISCONNECT CURVED JOINT PIPE Blockages may be cleared by separating the curved joint pipe 1 from the hose. To separate the curved joint pipe, pull the hose and press the two claws 4 that is clicked into the holes 6 on 6 )4 both sides of the joint pipe.
Page 10
TO REMOVE DUST When the dust accumulation is excessive, remove the dust by the following procedure. 1. Switch off the power supply and disconnect the power cord. 2. Remove the hose, and release the clamp ~ by pulling the lower side of it on each side and take off the upper case +.
Fig. 15 To remove dust 圖15 清除灰塵 —U³G « W «“« WOHOÂ ±µ qJý POWER CORD STORAGE To store the power cord /, wound the power cord and place it on the cord storage hook :. 放置電源線 要放置電源線/,請將電源線捲好,將它放置於 電源線掛勾:。 WOzUÐdNJ « WÁUD « pKÝ Êeš WÁUD «...
Page 12
TO STORE THE VACUUM CLEANER Hose, extension pipes and rug and floor tool can be stored in an assembled condition to the cleaner. This combination allows you a neat and tidy storage. 1. Slide the nozzle hook ; of the rug and floor tool into the hook supporter <...
Page 13
CARE OF FILTER Once or twice a year, to ensure good suction power, after disposing of the dust, clean the filter using the following method. 1. Take off the filter ring > from the packing ?. 2. Wash the filter @ in tepid water or a neutral detergent. If detergent is used, rinse it out thoroughly. 3.
Page 14
Electrical shock could occur if used outdoors or on wet surfaces. Before you plug in your Hitachi Vacuum Cleaner, make sure that the voltage indicated on the rating plate located on the back of the vacuum cleaner is the same as your local power supply.
Page 16
‰uBŠ V M−² p –Ë ÷dG « «cN hšdÄ h ý q³Á sÄ Ë« hšd*« UÄb)« qOÂË Ë« WF½UB « Ò ÆdÞU Ä THE HITACHI ATAGO BLDG. 15-12, Nishi-Shinbashi 2-chome, Minato-ku, Tokyo, 105-8410 Japan Tel : Tokyo (03) 3502-2111 3-J1861-5D...