Table of Contents
Available languages
Available languages
Your Black & Decker tool is equipped
with double insulation, hence, it does not
require to be earthed.
When the power cord is damaged, have it sent to
a Black & Decker service center for replacement to
specially prepared cables.
Using Extension Cords
If an extension cord is required, please select
a 3-phase extension cord that has been inspected
and matches the input power (see Technical
Data) of this tool. The minimum conductor size is
1.5 mm², maximum length is 30 meters.
When using a cable reel, be sure to pull out all the
cables.
Assembly and Adjustment
Warning! To minimize the danger of
serious personal injury, please switch
off the tool power and disconnect all
plugs before adjusting or removing/
installing any accessory. Before
reassembling the tool, press and release
the trigger switch to make sure the tool is
already switched off.
Attaching and Removing the Wheel
Guard (Fig. 2)
Warning! To minimize the danger of
serious personal injury, please switch
off the tool power and disconnect all
plugs before adjusting or removing/
installing any accessory. Before
reassembling the tool, press and release
the trigger switch to make sure the tool is
already switched off.
Attaching the guard
1. Place the angle grinder on a work bench,
groove facing up.
2. Bring the fl ange of the guard (c) collar over the
groove (i) of the gear housing.
3. Turn the guard (c) clockwise by 180 degrees.
4. Make sure that the screws (k) are tightened.
Removing the guard
1. Loosen the screws (k) on the guard collar.
2. Pull up the guard (c).
Warning! Do not operate the tool when
the safety guard is not in place.
Note: Refer to the grinding accessories chart at
the end of this section for accessories that can be
used together with this angle grinder.
Attaching and Removing Grinding Wheels
(Fig. 3, 4)
Warning! Do not use damaged grinding
wheels.
1. Place the tool on a work bench, groove facing
up.
2. Attach the inner fl ange (d) correctly on the
output shaft (e) (Fig. 3).
3. Place the grinding wheel (f) on the inner fl ange
(d). When attaching a grinding wheel with
a raised center, make sure that the raised
center (g) faces the inner fl ange (d).
4. Tighten the outer fl ange (h) until the output
shaft (e) (Fig. 4). When attaching the grinding
wheel, the ring on top of the outer fl ange (h)
must face the wheel.
5. Press the spindle lock (b) and prevent the
spindle (e) from rotating until it locks in place.
6. Use the pin spanner to tighten the outer fl ange
(h).
Preparation Before Use
•
Attach the safety guard and appropriate
abrasive or grinding wheels. Do not use
abrasive or grinding wheels that are overly
worn.
•
Make sure that the inner and outer fl anges are
attached correctly.
•
Make sure that the abrasive or grinding wheels
are rotating in the direction of the arrows on
the accessories and tool.
Operation (Fig. 5)
Instructions
Warning! Always observe the safety
instructions and applicable regulations.
Warning! To minimize the danger of
serious personal injury, please switch
off the tool power and disconnect all
plugs before adjusting or removing/
installing any accessory. Before
reassembling the tool, press and release
the trigger switch to make sure the tool is
already switched off.
ENGLISH
9
Table of Contents
