Table of Contents
3.3
Setting picking start time
When you set the picking
start time, you must set as follows.
@At
Screen 2, press [Mode
l] three times (twice
in case of M3099G)
to go to the PICK START
TIME
screen. (Screen 8)
Screen8
@ Press [Mode 21 to see Screen 9. (The default
Screen 9
@At
Screen 9, press [Mode
l] until the digit you
want to change blinks. Then press [Mode 21
until the digit changes as you want. (The
specifiable
range is from 0.2 to 29.8 sec. in 0.2
sec. step.)
@ Press [Mode
l] and [Mode 21 at a time to see
Screen 8. The settings
are stored to EEPROM.
@When
you close the setup mode, go to 8.
3.4 Setting picking time
When you set the picking
time, you must set as follows
@At
Screen 2, press [Mode
l] four times (three
times in case of M3099G)
to go to the PICK
Screen10
setting is 2 sec.)
Screen 11
@At
Screen 11, press [Mode
1) until the digit you
want to change blinks. Then press [Mode 21
until the digit changes as you want. (The
specifiable
range is from 0.5 to 99.5 sec. in 0.5
sec. step.)
@
Press [Mode
l] and [Mode 21 at a time to see
Screen 10. The settings
are stored to
EEPROM.
@When
you close the setup mode, go to 0.
c-4
M3099A/G
Operator's
Guide
Chapters
Table of Contents
