Scanner To Bioptic Communication; Scanner-Bioptic Packet Mode - Honeywell Hyperion 1300G User Manual
General purpose handheld linear scanner
Hide thumbs
Also See for Hyperion 1300G:
- User manual (188 pages) ,
- Quick start manual (13 pages) ,
- Get started (3 pages)
Table of Contents
for ACK/NAK again. Turn on the ACK/NAK protocol by scanning the ACK/NAK
On bar code below. To turn off the protocol, scan ACK/NAK Off. Default =
ACK/NAK Off.
ACK/NAK On
Scanner to Bioptic Communication
The following settings are used to set up communication between Honeywell
scanners and bioptic scanners.
Note: The scanner's baud rate must be set to 38400 and the RS232 timeout
must be set to 3000 in order to communicate with a bioptic scanner. See
"RS232 Modifiers" on page 2-22, and
further information.
Scanner-Bioptic Packet Mode
Packet Mode On must be scanned to set the scanner's format so it is compati-
ble with a bioptic scanner. Default = Packet Mode Off.
* Packet Mode Off
2 - 28
* ACK/NAK Off
RS232 Timeout
on page 2-27 for
Packet Mode On
Hide quick links:
Table of Contents
