Special Preset Commands, Pelco Protocol; Title - Bosch MIC550 User Manual

MIC Series 550

Keyboard Command User Action

2 – Aux On / Aux

Off

91 – Aux On

92 – Aux On

12.3.5

Some Pelco mode preset commands have a special meaning and override the normal Pelco

preset function as follows:

Preset Command

33-PRESET

34-PRESET

80-PRESET

81-PRESET

82-PRESET

92-PRESET

93-PRESET

94-PRESET

95-PRESET

96-PRESET

97-PRESET

98-PRESET

99-PRESET

Notice!

Some Pelco controllers do not support all of the preset command numbers. Refer to the

documentation of the specific Pelco controller for supported preset commands.

Bosch Security Systems, Inc.

Description

Press

Activates / deactivates alarm output 2.

This command is supported with Non-IR models

only if an optional 8-input alarm card is installed in

the PSU powering the camera.

Press

Activate Zone Scan (display zone titles).

Press

Deactivate Zone Scan (re-move zone titles)

Description

Pans the camera 180° (Flip).

Goes to Zero Pan (original home position).

Toggles the Synchronization Mode between Line Lock and Internal

(Pelco Frame Scan). This command is available if commands are

unlocked using the Main menu.

Initiates Preset Tour 1.

Initiates Preset Tour 2.

Sets the Left pan limit for an AutoScan with Limit Stops enabled.

Sets the Right pan limit for an AutoScan with Limit Stops enabled.

Initiates a Preset Tour.

Enables or disables Limit Stops in the Setup Menu for AutoScan.

Invokes the Pelco main Setup Menu when pressed for 2 seconds.

Stops a scan.

Initiates FastAddress (Pelco Random Scan).

Toggles the Synch. Mode between Line Lock and Internal (Pelco

Frame Scan). This command is available only for two (2) minutes after

the power is applied and then reverts to normal preset functionality.

Starts an AutoScan.

Operation Manual

Getting Started | en

33

November 2011 | | F.01U.239.454