Table of Contents
Quick Links
Table of Contents
Related Manuals for Jetmaster 60I
Summary of Contents for Jetmaster 60I
-
Page 2: Table Of Contents
Installation & Operation manual of Jetmaster UK clean burn range TABLE OF CONTENTS TABLE OF CONTENTS................2 TECHNICAL DATA..................3 DIMENSIONS ..................3 WARNINGS ...................4 INSTALLATION INSTRUCTIONS..............5 GENERAL ....................5 INSTALLATION REQUIREMENTS............5 CHIMNEY AND FLUES ...............6 OUTER BOX INSTALLATION ............7 APPLIANCE PREPORATION ..............9 Operating Instructions...................19 Lighting after Installation ................19... -
Page 3: Technical Data
Installation & Operation manual of Jetmaster UK clean burn range TECHNICAL DATA DIMENSIONS OUTER BOX SIZES MODEL WIDTH LENGTH HEIGHT All dimensions in mm FRAME SIZES MODEL WIDTH LENGTH HEIGHT All dimensions in mm ENGINE SIZES MODEL WIDTH LENGTH HEIGHT... -
Page 4: Warnings
Installation & Operation manual of Jetmaster UK clean burn range WARNINGS Do not place articles on or against this appliance. • Do not use or store flammable materials near this appliance. • Do not spray aerosols in the vicinity of this appliance while it is in operation. -
Page 5: Installation Instructions
Installation & Operation manual of Jetmaster UK clean burn range INSTALLATION INSTRUCTIONS GENERAL READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION. CLOSE ATTENTION TO THE DETAILS OF INSTALLATION WILL ENABLE YOU TO GET THE BEST RESULTS FROM YOUR FIRE. NOTE: THESE INSTRUCTIONS SHOULD BE RETAINED FOR FUTURE REFERENCE. -
Page 6: Chimney And Flues
Installation & Operation manual of Jetmaster UK clean burn range • Roll of Insulation • Door operating tool • Tin of Paint • Installation & Operating Instructions • Guarantee card CHIMNEY AND FLUES The flue and chimney must be inspected before installation to ensure that it is suitable for the appliance being fitted. -
Page 7: Outer Box Installation
Installation & Operation manual of Jetmaster UK clean burn range Flue Outlet Flow from the outlet must be totally free from any obstruction. Bends The ideal flue is straight and vertical. New chimneys must not deviate more than 45º from the vertical, but it is desirable that the deviations do not exceed 30º. - Page 8 If installing the fire in an existing fireplace, first remove all loose material from the recess and measure the opening and recess to ensure that the Jetmaster outer firebox will fit. The opening must be high and wide enough to allow the outer firebox to be pushed into position.
-
Page 9: Appliance Preporation
Installation & Operation manual of Jetmaster UK clean burn range APPLIANCE PREPORATION Door Removal Unlock the door with the handle provided. Open the door fully and carefully support the door, at the same time pull out the top and bottom hinge pins. - Page 10 Installation & Operation manual of Jetmaster UK clean burn range Tertiary Air Tube Removal and Lower V Board Baffle Removal The sequence for easy removal of the air tubes and lower V board baffles are thus:- First remove the front tertiary air tube closest to the door of the fire.
- Page 11 Installation & Operation manual of Jetmaster UK clean burn range If needed then the remaining components can be removed. Cast Bottom Grate Removal The cast bottom grate can be removed by lifting up at the front or side edges. Care should be taken to ensure that the V boards each side of the grate do not become damaged.
- Page 12 Installation & Operation manual of Jetmaster UK clean burn range Rear V Board Removal Remove the rear left and right vertical V boards by gently pulling one edge out first sliding forward. Note they are handed for replacement with a cut out in the corners.
- Page 13 Installation & Operation manual of Jetmaster UK clean burn range Larger voids around the box can be filled with a non combustible insulation. Once in position fix the outer box by drilling through the fixing holes located in the base and screw/bolt to the base of the opening using suitable fixings.
- Page 14 Installation & Operation manual of Jetmaster UK clean burn range Inner Firebox “Engine” Fitting Slide the inner box “engine” into the outer box. The engine contains easy grip areas that allow 2 people to easily lift and slide the engine in place. Guides allow for easy location. Ensure that the inner box slides all the way to the rear of the outer box.
- Page 15 Installation & Operation manual of Jetmaster UK clean burn range Once the fire has been fitted then replacement of the internal parts can be finished. Refit the fire components by reversing the sequence of steps above in the removal section.
- Page 16 Installation & Operation manual of Jetmaster UK clean burn range The basket can be slide into the firebox centrally. It should be pushed back to the rear of the firebox and then pulled foreword slightly by a few millimetres to allow a small air space between the rear of the basket and the inside back of the firebox.
- Page 17 Lighting after installation The Jetmaster should not be run hard until all cement and plasterwork is completely dry and cured. When installation has involved building in cement mortar allow:- 7 days drying time if the house has other forms of heating.
- Page 18 Installation & Operation manual of Jetmaster UK clean burn range We recommend that chimneys should be swept at least twice a year during the burning season. More frequent sweeping may be necessary where fires are burned throughout the year or where low grade woods or bituminous coal are used as fuels.
-
Page 19: Operating Instructions
Operating Instructions Lighting after Installation A Jetmaster should not be run hard until all cement and plasterwork is completely dry and cured. As a basic guide the installer should Allow a 7-day drying time if the house has other forms of heating. -
Page 20: Basket Grates
Installation & Operation manual of Jetmaster UK clean burn range When lighting the fire, the air control should be opened fully by sliding the operating lever to the fully open position. The fire may be lit using proprietary firelighters with kindling wood. The door should be left slightly open when lighting. -
Page 21: Seasonal Use
Installation & Operation manual of Jetmaster UK clean burn range Seasonal Use In the summer months or at times when the fire is not being used then the air supply lever may be closed to eliminate draughts and to minimise the air loss from the room. - Page 22 Installation & Operation manual of Jetmaster UK clean burn range Ensure that any soot that has fallen on to the top of the V board baffles is removed. Ensure that any soot that has accumulated around the tertiary air tube holes is removed.