Table of Contents
Quick Links
Installation Instructions
Outdoor kit
For models: C1210ESC, C1210ES, C1050ES, 940ESO, 940ES,
830ES
Part no. BTOK
Warning: This kit must be installed by a qualified
installer in accordance with these instructions and
all applicable codes and requirements of the
authorities having jurisdiction.
6720645551-00.1V
Table of Contents
Related Manuals for Bosch BTOK
Summary of Contents for Bosch BTOK
- Page 1 Installation Instructions Outdoor kit For models: C1210ESC, C1210ES, C1050ES, 940ESO, 940ES, 830ES Part no. BTOK 6720645551-00.1V Warning: This kit must be installed by a qualified installer in accordance with these instructions and all applicable codes and requirements of the authorities having jurisdiction.
-
Page 2: Outdoor Installation
Outdoor installation Outdoor installation Warnings Danger: the water in this appliance is cold and always remains cold except for Danger: The top of the outdoor kit will the times when the burner is on. In the get very hot during operation. Keep event of power outage in conjunction away from children. -
Page 3: Selecting Heater Location
Selecting heater location Selecting heater location Before proceeding, read the water heater installation Best practice note: The clearances in manual. If the information in that manual is not followed Fig. 1 and table 1 are the minimum exactly, a fire, explosion or poisoning by carbon monox- allowed by the standard. - Page 4 Installing outdoor kit Installing outdoor kit Replace the control panel shield B After replacing the control panel shield re-position the front cover. B Loosen the two Philips head screws located on bottom rear of cover (see Fig. 2). B 1. Remove the cover plate (A) from the top of the appliance, as shown in Fig.
- Page 5 Installing outdoor kit B 3. Attach the gasket provided with the kit as shown in Fig. 6. 6720645551-15.1V Fig. 6 B 4. Install supplied Freeze Prevention Kit (separate packaging). Follow separate installation instructions 6720645551-12.1V provided with Freeze Prevention. Fig. 8 Note: Freeze Prevention is not designed to protect the appliance during long durations NOTE: Once this kit is installed, the...
-
Page 6: Mounting Instructions
Mounting instructions Mounting instructions B The water heater is approved for installation directly on an outside wall. Secure the wall mounting bracket provided with the water heater to a wall surface. See Fig. 9. B The installation method of the mounting bracket will 3½’... - Page 7 Recess box - Outdoor installation Recess box - Outdoor installation Warnings Danger: The top of the outdoor kit will get very hot during operation. Keep away from children. Install heater in a location where the top of the kit cannot be reached by small children.
-
Page 8: Installations
Installations Installations Installation only with Recess box Installing outdoor vent cap on the appliance This outdoor kit is intended to be installed together with recess box. Warning: The control panel shield must always remain closed, except when making adjustments, to prevent damage to heater from weather. - Page 9 Installations B Attach the outdoor vent cap to the appliance by fas- B Place the protection grill in the Outdoor vent cap. tening the two provided screws and washers, see Fig. 15. 6720645551-05.1V Fig. 17 B Fix the frame and protection grill with two screws. 6720645551-02.1V Fig.
- Page 10 Installations B Position the recess box cover as showed in Fig. 19. B Fix the frame to the recess box cover with 4 screws and silicone washers. 6720645551-07.1V Fig. 19 6720645551-09.1V Fig. 20 6 720 645 551...
- Page 11 Installations B Close the recess box cover with padlock (optional). 6720645551-08.1V Fig. 21 6 720 645 551...
-
Page 12: Electrical Connections
Electrical connections Electrical connections Electrical power supply safety reasons, Warning: disconnect the power supply cord to the heater before any service or testing is performed. Warning: This heater must electrically grounded in accordance with the most recent edition of the National Electrical Code. - Page 13 Measuring carbon dioxide (CO2) Measuring carbon dioxide (CO Note: After installation of the outdoor vent cap, measuring CO for proper levels is recommended before operating the appliance. See water heater installation manual for details. Warning: Outdoor vent cap will get very hot during operation.
- Page 14 Notes Notes 6 720 645 551...
- Page 15 Notes 6 720 645 551...
- Page 16 6720645551 Replacement Parts available from: BOSCH THERMOTECHNOLOGY CORP. 50 Wentworth Avenue Bosch Termotecnologia, S.A. Londonderry, NH 03053 Estrada de Cacia Tel. 866-330-2730 www.boschpro.com 3800 - 533 Cacia - PORTUGAL © 2010 Bosch Thermotechnology Corp., Londonderry, NH...