Table of Contents
Install Cycle (WaveTouch™)
1. The machine will first wake up on setting up
the unit to display language selection. Press
NEXT to display the Install cycle. The Install
cycle can be run at this time. If not, the Install
cycle can be accessed through the PREF
menu in the option window. Press the select
key once you scroll to the PREF selection.
Then scroll through this menu until you get to
the Install cycle. Press the select key then
follow the instructions (remove all articles from
the washer drum).
You can also get to this cycle by performing a
full reset of factory settings.
2. At cycle completion, the LCD window may
display "INSTALL PASS!", meaning the washer
is properly installed and ready for use. If it
prompts an action such as "NO WATER",
"CHECK HOSES" or "CALL SERVICE 877-
435-3287", review the installation steps and
make the necessary corrections before
attempting to use the washer.
3. The washer will exit the Installation Cycle and
return to normal operation the next time the
washer is used.
Install Cycle (IQ Touch™)
1. Wake the washer up by pressing any button
(except the cancel button).
2. Rotate the cycle knob to the "HAND WASh"
cycle.
3. Press the START/PAUSE button, then the
CANCEL button.
4. Wake the unit up again, immediately and
simultaneously press and hold the MY
FAVORITE and ECO FRIENDLY buttons for
5 seconds. The display will show "INSTAL
CYCLE" with the estimated time of cycle
completion.
5. Press the START/PAUSE button to begin the
cycle. Installation cycle will test for electronic
issues, wiring issues & water flow issues. At
cycle completion, the display will show
INSTAL PASS!" or prompt an action during
the cycle such as "CALL SERVICE", "NO
WATER" or "CHECK HOSES". Correct the
action and repeat the cycle for proper
installation. Washer will exit the Install Cycle
and return to normal operation the next time
the knob is turned.
Electronic Control
NOTE
The INSTALL CYCLE is prompted automati-
cally only once when the washer is turned on
the first time at the end of installation. After
that, if you wish to run a subsequent
INSTALL CYCLE when moving the washer or
modifying your installation, you may perform
your own INSTALL CYCLE by selecting it in
the set prefs feature and then following the
screen prompts.
NOTE
Washer will stay awake for 3 minutes after
the Installation Cycle. If you wish to immedi-
ately run the washer through a washing
cycle, press the cancel button to put the unit
to sleep and then rewake it immediately, to
continue the normal operating mode.
The errors may result from the following
conditions:
• NO WATER error — Water inlet hoses have not
been attached to water supply or water supply
valves have not been turned on. Install hoses
correctly and turn on water supply valves.
• CHECK HOSES error — The hot inlet hose
may have been connected to the cold water
supply and the cold inlet hose may have been con-
nected to the hot water supply. Check hoses for
correction supply connection. If incorrect,
disconnect hoses and connect to correct inlets
according to Installation Instructions.
• CALL SERVICE —Troubleshoot and repair as
needed. Repeat the INSTALL CYCLE when
corrections are completed.
3-19
Hide quick links:
Table of Contents
