GE Café series Installation Instructions Manual

Hide thumbs Also See for Café series:

Dimensions and installation information (3 pages)

Owner's manual (78 pages)

Installation instructions manual (48 pages)

Table Of Contents

page of 27

/ 27
Contents
Table of Contents

Quick Links

Installation

Instructions

Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com

In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING

Built-in style models (model PYE, CYE, and PWE) are

top heavy, especially with any doors open. These

models must be secured with the anti-tip floor

bracket to prevent tipping forward, which could

result in death or serious injury. Read and follow

the entire installation instructions for installing the

anti-tip floor bracket packed with your refrigerator.

IMPORTANT

Observe all governing codes

and ordinances. Save these instructions for local

inspector's use.

Note to Installer – Be sure to leave these instructions with

the Consumer.

Keep these instructions for future

reference.

Installation of this appliance requires basic

mechanical skills.

Refrigerator Installation can vary

Water Line Installation 30 minutes

under the Warranty.

PREPARATION

MOVING THE REFRIGERATOR INDOORS

If the refrigerator will not fit through a doorway, the

refrigerator door and freezer drawer can be removed.

Refrigerator section.

Freezer Drawer section.

WATER SUPPLY TO THE ICE MAKER AND DISPENSER

If the refrigerator has an ice maker, it will have to be

connected to a cold water line. A GE water supply

kit (containing tubing, shutoff valve, fittings and

instructions) is available at extra cost from your dealer,

by visiting our website at GEAppliances.com (in Canada

at www.GEAppliances.ca) or from Parts and Accessories,

800.626.2002 (in Canada 1.800.661.1616).

Tip Over Hazard.

TOOLS YOU MAY NEED

Adjustable Wrench

1/4" Outer Diameter

Compression Nut

and Ferrule (sleeve)

1/8", 3/32", 1/4" & 5/32"

Allen Wrenches

1/8" Drill Bit and

Electric or Hand Drill

Pencil

Pliers

Torx T20, T25

Refrigerator

GE Café™ models

Socket Ratchet/Driver

Phillips-Head Screwdriver

Flat-Head Screwdriver

Tape Measure

1/4" Nut Driver

Level

Table of Contents

Summary of Contents for GE Café series

Page 1: Before You Begin
Installation Refrigerator Instructions GE Café™ models Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca BEFORE YOU BEGIN TOOLS YOU MAY NEED Read these instructions completely and carefully. WARNING Tip Over Hazard.
Page 2: Moving The Refrigerator
Installation Instructions DIMENSIONS All measurements are given with leveling leg fully retracted. CYE Only CFE Only Case Depth w/o ” ” ” Doors 29 ” CFE ” CYE Height from floor to hinge cover top 69 ” ” ” 69” 69”...
Page 3: Installing The Refrigerator
Installation Instructions INSTALLING THE REFRIGERATOR REMOVE THE FRESH FOOD REFRIGERATOR LOCATION DOOR HANDLE Handle Design varies based on models, however go below 60°F (16°C) because it will not run often enough Installation is same. to maintain proper temperatures. Stainless steel and plastic handles: Loosen the set screws with the 1/8”...
Page 4: Installation Instructions
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) REMOVE THE REFRIGERATOR DOORS REMOVE THE REFRIGERATOR DOORS (cont) Securely tape the door shut with masking tape or have Disconnect the water line from the back of the unit by a second person support the door. pressing down on the dark grey collar while pulling up on the water line.
Page 5 Installation Instructions INSTALLING THE REFRIGERATOR (cont.) REMOVE THE REFRIGERATOR DOORS (cont) REINSTALLING THE REFRIGERATOR DOORS Reverse steps 1 through 4 to reinstall refrigerator, follow details below for critical alignments. Note: for proper installation later, please follow the next step carefully. Reinstall center hinge first and torque the screws to Fresh Food doors to be REMOVED and INSTALLED 65 in-lbs.
Page 6: Replacing The Freezer Door
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) REMOVE THE FREEZER DOOR REPLACING THE FREEZER DOOR Pull the freezer door open to full extension. Pull the slide Mechanism to full extension using both Remove 3 attachment screws, located at the bottom hands simultaneously. on each side of the freezer door using 3/8”...
Page 7 0.6” o inferior. Set Screw Vis d’ajustement Step 2 Step 3 Tornillo del Set Étape 2 Étape 3 Paso 2 Paso 3 GE Appliances General Electric Company Louisville, KY 40225 Refer to 239D4144P001 Pub No. 31-45474-2 11-12 GE GEAppliances.com...
Page 8: Remove Packaging
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) LEVEL THE FREEZER DOOR LEVEL THE FREEZER DOOR (cont.) Lift the door on the side requiring adjustment, rotate the cam to required position. 0 - Initial position 1 - Lift by 0.050” -1 - Lower by 0.050” -2 - Lower by 0.100 -3 - Lower by 0.150”...
Page 9: Tools You Will Need
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) Anti-Tip Floor Bracket Installation (Models PYE, CYE, and PWE only) TOOLS YOU WILL NEED WARNING Tip Over Hazard. 1/8” (3 mm) Drill Bit and Tape measure Electric or Hand Drill Built-in style models (model PYE, CYE, and PWE) are top heavy, especially with any doors open.
Page 10: Anti-Tip Bracket Installation
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) Anti-Tip Floor Bracket Installation (Models PYE, CYE, and PWE only) (cont.) LOCATING THE ANTI-TIP FLOOR CONCRETE Wall and Floor Construction: AT-2 BRACKET (cont.) 4 each 1/4” (6 mm) x 1-1/2” (38 mm) lag bolts Figure 2 –...
Page 11 You may need to pry open the clamp. sand or particles that could clog the screen of the refrigerator’s water valve. Install it in the water line near the refrigerator. If using GE SmartConnect ™ Refrigerator Tubing Kit, you will need an additional tube (WX08X10002) to connect the filter.
Page 12: Plug In The Refrigerator
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) TURN ON THE WATER SUPPLY LEVEL THE REFRIGERATOR DOORS Remember a level refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator. When When the left the left...
Page 13 Installation Instructions INSTALLING THE REFRIGERATOR (cont.) Refrigerator Assembly Instructions, suggested assembly. Divider (Select models only) To place bins into doors: Match your bin with the letter shown. Position the bin hooks over the bin locator and push forward until inserted fully. Bin hook rear each side Push bin down until locked into...
Page 14: Installing The Water Line
If using Osmosis Water System, the only approved installation copper, be sure both ends of the tubing are is with a GE RVKit. For other reverse osmosis water cut square. systems, follow the manufacturer’s recommendations.
Page 15 (cont.) Install the shutoff valve on the nearest frequently used drinking water line. WHAT YOU WILL NEED (CONT.) NOTE: The only GE approved plastic tubing is that supplied in GE SmartConnect Refrigerator ™ SHUT OFF THE MAIN WATER SUPPLY Tubing kits. Do not use any other plastic water...
Page 16 Pipe Clamp Make sure the tubing is fully inserted into the valve. Tighten the compression nut securely. For plastic tubing from a GE SmartConnect ™ Refrigerator Tubing kit, insert the molded end of the tubing into the shutoff valve and tighten...
Page 17: Normal Operating Conditions
Normal operating conditions. Newer refrigerators sound different from older refrigerators. Modern refrigerators have more features and use newer technology. Do you hear what I hear? These sounds are normal. HUMMM... WHOOSH... The new high efficiency compressor may run faster and longer than your old refrigerator and you may hear a high-pitched hum You may hear the fans spinning at high speeds.
Page 18: Before You Call For Service
Before you call for service… Troubleshooting Tips Save time and money! Review the charts on the following pages first and you may not need to call for service. Problem Possible Causes What to Do Water filter indicator light Water filter indicator must be reset On the LCD screen select remains lit after replacing filter system SETTINGS, then WATER FILTER.
Page 19 GEAppliances.com Troubleshooting Tips (cont) Problem Possible Causes What to Do No water or ice cube production Supply line or shutoff valve is clogged Call a plumber Water filter is clogged Replace filter cartridge or remove filter and install bypass plug Filter cartridge not properly installed Remove and reinstall filter cartridge, being certain that it locks in place.
Page 20 Before you call for service, review the detailed troubleshooting tips in the Owner’s SERVICE manual. If needed, service can be scheduled by visiting us online GEAppliances. com or calling 800.ge.CARES 800.432.2737 Truth or Myth Truth or Myth? Answer Explanation The refrigerator water filter may require replacement,...
Page 21 Before you call for service, review the detailed troubleshooting tips in the Owner’s SERVICE manual. If needed, service can be scheduled by visiting us online GEAppliances. com or calling 800.ge.CARES 800.432.2737 Truth or Myth (cont.) Truth or Myth? Answer Explanation Door removal is always required for installation.
Page 22: Refrigerator Warranty
GE with information on your appliance. If you do not want your appliance data to be sent to GE, please advise your technician NOT to submit the data to GE at the time of service.
Page 23: Rpwf Water Filter Cartridge Limited Warranty
Date * If your GE part fails because of a manufacturing defect within thirty days from the date of original purchase for use, we will give you a new or, at our option, a rebuilt part without charge. Return the defective part to the parts supplier from whom it was purchased together with a copy of the “proof of purchase” for the part. If the part is defective and shows no signs of abuse, it will be exchanged.
Page 24: Performance Data Sheet
System tested and certiﬁ ed by NSF International against NSF/ANSI Standard Appliances 42 and Standard 53 in model GE RPWF for the reduction of the claims speciﬁ ed Appliance Park on the performance data sheet.
Page 25 2110 Date Issued: November 16, 2011 Trademark/Model Designation Replacement Elements GE RPWF RPWF Manufacturer: 3M Purification Inc. The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section 116830 of the Health and Safety Code for the following health related contaminants:...
Page 26: Consumer Support
Contact Us GEAppliances.com In the U.S.: If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations GE Appliances, Appliance Park Louisville, KY 40225 In Canada: www.GEAppliances.ca, or write to:...

This manual is also suitable for:

Cafe cfe series Cafe cye series