Table of Contents
10. Connect one green end of 3-in-1 cable to PS/2 keyboard port on the host
computer/KVM, and the other end of 3-in-1 cable to the host PS/2 keyboard port on the
DKVM-IP8 switch.
11. (Optional) Connect the type A connector of USB A - mini USB 5P cable to the host
computer,
while using remote mass storage control.
12. Connect Ethernet to LAN port and/or modem to serial port, depending on how you want
to access DKVM-IP8 switch
13. Power on the computer.
1.2 Initial IP configuration
In factory default, DHCP mode is disabled (IP auto configuration = None), and the IP
settings are as below:
IP address
Subnet mask
Default Gateway
If DHCP mode is enabled (IP auto configuration = DHCP), the DKVM-IP8 will try to
contact a DHCP server in the subnet to which it is physically connected. If a DHCP
server is found, it may provide a valid IP address, gateway address and net mask.
Before you connect the device to your local subnet, be sure to complete the
corresponding configuration of your DHCP server. It is recommended to configure a
fixed IP assignment to the MAC address of the DKVM-IP8 unit. You can find the MAC
address labeled on the bottom side of the metal housing.
192.168.0.70
255.255.255.0
None
7 / 104
DKVM-IP8 User Manual
- Quick Links:
- Initial Ip Configuration
Hide quick links:
Table of Contents
