Sanyo DP42142 Service Manual page 14

MECHANICAL DISASSEMBLY (Continued)

RC BOARD REMOVAL

Remove 1 screws (C:3x10) to take the RC BOARD off.

MOUNTING WALL REMOVAL

Remove 2 nuts (G) from the cabinet back

ATTENTION

– Confirm Mounting wall wire is installed when you install

the back cabinet.

– Need to use the hot-melt method to remove the mount-

ing wall, generally need not remove the mounting wall

through servicing.

Many solid-state devices (especially Integrated Circuits) are Electrostatically Sensitive,

and, therefore, require special handling techniques as described under "Servicing

Electrostatically Sensitive Devices," on page two in this service literature.

ELECTROSTATICALLY SENSITIVE DEVICES

– 8 –