Table of Contents
5.4
Setting the controller back to default values
If Pr 00 is set to a non-zero value and edit mode is exited, the field controller is reset
when the field controller is inactive (Pr 77= OFF), the selected default parameters will
automatically be loaded. After the parameters have been set to default values, they are
automatically saved to the field controller's EEPROM on power down. New values will
take effect on subsequent power up.
Table 5-1 Pr 00 settings
Value
0
1
2
If loading default when the drive is active, the display will flash FAIL once and then
NOTE
Pr 00 will be change back to nonE.
Table 5-2 Status modes
Left hand
display
To set defaults from MP or MII Mode, set Pr 78 = OFF then press
A power cycle is then required to gain access to Pr 00.
5.5
Saving parameters
Parameters are automatically saved when the
from parameter edit mode to parameter view mode.
A parameter change is not saved if a drive trip occurs when the parameter is changed.
NOTE
FXMP25 User Guide
Issue Number: 3
Display
nonE
No action
Eur
Load European defaults
USA
Load USA defaults
Status
Field controller
The field controller is inhibited because the field controller
inhibited
is disabled (Pr 77 = OFF).
The field controller has tripped. The trip code will be
Field controller has
displayed in the 'right hand' display
tripped
(see Chapter 9 Diagnostics on page 60).
The field controller is in a run state.
Pr 78 = Mode Selected an
Field controller is
Pr 77=On Standalone Mode or
running
Mentor MP Pr 5.77=On in MP Mode or
Mentor II ribbon cable is connected in Mentor II mode.
www.controltechniques.com
Function
Explanation
MODE key is pressed when going
M
to exit edit mode.
M
29
Hide quick links:
Table of Contents
