Table of Contents
Scanning from the Glass
While scanning is in progress, the LCD panel displays the Glass Scanning
Status screen. After the last page is scanned, the Waiting for Next Page
screen opens.
1
Do one of the following:
2
Press F
the Template Selection List screen opens. Scanned image data is
saved on the controller hard disk.
ADF Scanning
Follow the steps in this section to use the ADF in continuous scan mode.
While scanning is in progress, the LCD panel displays the ADF Scanning
Status screen.
1
To scan more originals after the current job ends, press C
If you do not press C
controller hard disk automatically, and you return to the Template
Selection List screen. The Waiting for Continuous Scan screen opens
after the last page is scanned.
2
To scan another job, place the originals on the ADF and press S
or
3
To finish scanning, press F
Template Selection List screen opens. The scanned image data is
saved on the controller hard disk.
30
To scan another job, press S
another original on the glass.
To cancel the job, press C
screen opens. Press Y
To change the scan settings in the Scan Parameter Setting
screen, press S
ETTING
Parameter Settings
to end this scanning session. When scanning is complete,
INISH
.
START
To stop the ADF scan during continuous mode, press
To cancel the job, press C
screen appears.
Press Y
to cancel the Job. To prevent cancellation, press N
ES
To change the scan settings, press S
Parameter Setting screen. For further information, refer to
Parameter Settings
! or
CAN
J
ANCEL
OB
to cancel the job or N
ES
. For further information, refer to
on page 31.
, scanned image data is saved on the
ONTINUE
J
ANCEL
OB
on page 31.
. When scanning is complete, the
INISH
GL-10x0 Scan Operator's Guide
again after placing
START
or
. The Cancel Confirm
FC
to continue.
O
or
. The Cancel Confirm
FC
in the Scanning
ETTING
Scan
.
ONTINUE
!
CAN
.
CLEAR/STOP
.
O
Scan
Table of Contents
