Replacing Components; Replacing The Fan Tray Assembly - HP ProCurve Series 6600 Installation And Getting Started Manual
Procurve 6600 series switches
Hide thumbs
Also See for HP ProCurve Series 6600:
- Security configuration manual (559 pages) ,
- Command reference manual (286 pages) ,
- Configuration manual (236 pages)
Table of Contents
Replacing Components
This chapter shows you how to remove and install the following components:
■
■
■
H o t S w a p p i n g
The battery cannot be hot swapped. The switch must be powered off to replace
the battery because the top must be removed.
C a u t i o n
The HP ProCurve Series 6600 Switch and its components are sensitive to static
discharge. Use an antistatic wrist strap and observe all static precautions
when replacing components.
Replacing the fan tray assembly
When a fan fails the Fan Status LED on the switch chassis will blink
simultaneously with the switch Fault LED. In this case, the entire fan tray
assembly needs to be replaced. Individual fans cannot be replaced.
The fan tray assembly is hot swappable. It can be removed and replaced
without removing power from the switch. However, install the new fan tray
assembly immediately (within two minutes) after removing the old fan tray
assembly to avoid overheating and switch shutdown.
W A R N I N G
To avoid contact with spinning fans, if you are hot swapping out the
fan tray assembly, pull the assembly out one-inch and allow the fans
to stop rotating (approximately 5 seconds) before pulling it all the
way out.
Fan tray (see
page
4-1)
Battery (see
page
4-3)
Power Supplies (see
page
Replacing the fan tray assembly
4-5)
Replacing Components
4
4-1
Hide quick links:
Table of Contents
