Connect The Switch To A Power Source; Securing The Power Cord - HP ProCurve Series 6600 Installation And Getting Started Manual
Procurve 6600 series switches
Hide thumbs
Also See for HP ProCurve Series 6600:
- Security configuration manual (559 pages) ,
- Command reference manual (286 pages) ,
- Configuration manual (236 pages)
Table of Contents
Installing the Switch
Installation Procedures
5. Connect the Switch to a Power Source
1.
2.
Securing the power cord
2-14
Plug the included power cord into the switch's power connector and into
a nearby AC power source.
Re-check the LEDs during self test. See "LED Behavior" on
1.Connect the power cord to the power supply.
2.Make a small loop in the power cord, approximately 3 to 4 inches
and insert the velcro strap through the loop and through the handle
on power supply.
3.Insert the end of the velcro strap through the slot in the other end
of the velcro strap.
4.Tighten the velcro strap around the loop in the power cord.
5.Wrap the excess velcro strap around the power cord loop and
through the power supply handle a couple of times and secure the
velcro strap to itself.
1.
2.
page
2-7.
Hide quick links:
Table of Contents
