Using Your Ceiling Fan - Emerson BUILDER UNIPACK CF701BS00 Owner's Manual

52” ceiling fan

Hide thumbs Also See for BUILDER UNIPACK CF701BS00:

Owner's manual (16 pages)

Owner's manual (12 pages)

Table Of Contents

Table of Contents

Enlarged version

WARNING

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not

operate fan until blades are in place. Noise and fan

damage could result.

3. Screw the two threaded studs (supplied) into the

tapped holes in the hanger bracket.

4. Lift the ceiling cover up to the threaded studs and

turn until studs protrude through the holes in the

ceiling cover (Figure 13).

5. Secure the ceiling cover in place by sliding

lockwashers over the threaded studs and installing

the two knurled knobs (supplied). (Figure 13.)

Tighten the knurled knobs securely until the ceiling

cover fits snugly against the ceiling and the hole in

the ceiling cover is clear of the downrod. Your fan

is now wired to be turned on and off from the fan

switch.

THREADED STUD

KNURLED KNOB

Figure 13

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the outlet box

and not pinched between the ceiling cover and the

ceiling.

6. Cut the 3-speed switch pull chain to a desired

length (optional). Connect the wood pendant

(supplied) to the 3-speed switch pull chain by

sliding the wooden pendant (small hole first) onto

the pull chain. Attach the chain coupler to the end

of the chain and allow the wooden pendant to fall

down over the coupling.

1. Restore electrical power to the outlet box by turning

the electricity on at the main fuse box.

2. Check the operation of the light by gently pulling on

the light switch pull chain.

3. Check the operation of the fan by gently pulling on

the speed control switch pull chain. The operation

sequence is as follows:

1st pull - High

2nd pull - Medium

4. Your fan is shipped from the factory with the

reversing switch positioned to circulate air

downward. If airflow is desired in opposite

direction, turn the fan off and wait for the blades to

stop turning, then slide the reversing switch to the

opposite position, and turn the fan on again. The

fan blades will turn in the opposite direction and

reverse the airflow.

CEILING COVER

LOCKWASHER