Enabling/Disabling 802.1X; Setting The Port Access Control Mode - Huawei Quidway S3000-EI Series Operation Manual
Hide thumbs
Also See for Quidway S3000-EI Series:
- Operation manual (392 pages) ,
- Installation manual (74 pages) ,
- Operation manual (21 pages)
Table of Contents
Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches
Configuring 802.1x dynamic user binding
Setting the maximum times of au
Configuring timers
Enabling/disabling a quiet-period timer
Among the above tasks, the first one is compulso
effect. The other tasks are optional. You can perform the configurations a
requirements.
1.2.1 Ena
bling/Disabling 802.1x
The following co
or globally. When it is used in system view, if the parameter interface-list is not specified,
802.1x will be globally enabled
enabled on the specified port. When this command is used in Ethernet port view, the
parameter interface-list cannot be input and 802.1x can only be enabled on the current
port.
Perform the following configurations in system view or Ethernet port view.
Table 1-1 Enabling/disabling 802.1x
Enable the 802.1x
Disable the 802.1x
You can config
c
onfiguration will take
By default, 802.1x authentication has not be
1.2.2 Setting the Port Access Control Mode.
The following commands can be used for setting 802.1x access c
specified port. When no port is specified, the access control mode of all ports is
configured.
Perform the following configurations in system
Table 1-2 Setting the port access control mode.
Set the port
Restore the default access control mode
of the port.
mmand can be used to enable/disable the 802.1x on the specified port
. If the parameter interface-list is specified, 802.1x will be
Operation
ure 802.1x
on individual port before i
effect right after 802.1
Operation
access control mode.
Huawei Technologies Proprietary
1-4
Chapter 1 802.1x Configuration
thentication request message retransmission
ry, otherwise 802.1x will not take any
Command
dot1x [ interface interface-list ]
undo dot1x [ interface interface-list ]
t is enabled
x is enabled globally.
en enabled globally and on any port.
view or Ethernet port view.
Command
dot1x port-control { authorized- force
|
unauthorized-force
[ interface interface-list ]
undo dot1x port-control [ interface
interface-list ]
t
globally. The
ontrol mode on the
|
auto
}
Hide quick links:
Chapters
Table of Contents
Troubleshooting
