Enable/Disable A Stack; Switch To A Slave Switch View To Perform The Configuration - Huawei Quidway S3000-EI Series Operation Manual
Hide thumbs
Also See for Quidway S3000-EI Series:
- Operation manual (392 pages) ,
- Installation manual (74 pages) ,
- Installation manual (7 pages)
Table of Contents
Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches
Table 1-1 Configure IP address pool for the stack
Configure IP address range for a stack
Restore to the default IP address range
Before setting up a stack, the user should configure a public IP address pool for the
slave switch of the stack.
Please note that the above configurations can only be performed on the non-stack
switches. After a stack is enabled, the user is prevented from modifying the IP address
pool.
1.2.2 Enable/Disable a Stack
When the user enables a stack with the following command, the system will
automatically add the switches, connected to the main switch via stack ports, to the
stack. After a stack has been enabled, if the stack port is disconnected, slave switch will
exit the stack automatically.
Perform the following configuration in sy
Table 1-2 Enable/Disable a stack
Enable a stack
Disable a stack
P
lease note that you can only operate on the main switch to disable a stack.
1.2.3 Swi
tch to a Slave Switch view to Perform the Configuration
The following command can be used to switch from the main switch vi
switch view to change the configuration.
Please perform the following configurations in user view.
Table 1-3 Switch to a slave switch view to perform the configuration
Switch to a slave switch view to perform
the configuration
Please note that the above command can
s
witch view to a slave switch view and the user level remains the same after switching.
To switch from a slave switch view back to a main switch view, input quit.
Operation
Operation
Operation
Huawei Technologies Proprietary
1-2
Chapter 1 Stack Function Configuration
Command
stacking
ip-pool
ip-address-number [ ip-mask ]
undo stacking ip-pool
stem view.
Command
stacking ena ble
undo stacking enable
Command
stacking num
only be used fo
r switching from the main
from-ip-address
ew to a slave
Hide quick links:
Chapters
Table of Contents
Troubleshooting
