Connection And Operation - Emerson Liebert GXT-MT User Manual

Liebert GXTMT Series

1-3 kVA UPS

The system may be installed and wired only by qualified electricians in

accordance with applicable safety regulations

When installing the electrical wiring, please note the nominal amperage of

your incoming feeder

1)

Inspection:

Inspect the packaging carton and its contents for damage. Please inform the transport agency

immediately should you find signs of damage. Please keep the packaging in a safe place for future use.

Note: Please ensure that the incoming feeder is isolated and secured to prevent it from being

switched back on again.

2)

Connection:

2.1) UPS Input Connection

If the UPS is connected via the power cord, please use a proper socket with protection against

electric current, and pay attention to the capacity of the socket: over 10A for 1KVA & over 16A for

2KVA & 3KVA.

2.2) UPS Output Connection

The output of the UPS is CE socket-types only. If the load is couple of PCs simply plug the load

power cord to the output sockets to complete connection. However, if there are more loads, cut the

load end of the load power cord and wire to the extension board. Use one cord for every 5A load.

Model No.

GXT1000-MT / GXT1000L-MT

GXT2000-MT / GXT2000L-MT

GXT3000-MT / GXT3000L-MT

Page １０

Output Socket (pcs)

4(CE)

6 / 4(CE)

4(CE)

V2.11

Installation and User Manual

Connection and Operation

Terminal Block

Nil

Nil /Available

Available

Emerson Network Power