Cisco Catalyst 3550 Command Reference Manual page 166
Multilayer switch
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (662 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
ip arp inspection log-buffer
Examples
This example shows how to configure the logging buffer to hold up to 45 entries:
Switch(config)# ip arp inspection log-buffer entries 45
This example shows how to configure the logging rate to 20 log entries per 4 seconds. With this
configuration, the switch generates system messages for five entries every second while there are entries
in the log buffer.
Switch(config)# ip arp inspection log-buffer logs 20 interval 4
You can verify your settings by entering the show ip arp inspection log privileged EXEC command.
Related Commands
Command
arp access-list
clear ip arp inspection log
ip arp inspection vlan logging
show ip arp inspection
Catalyst 3550 Multilayer Switch Command Reference
2-140
Description
Defines an ARP access control list (ACL).
Clears the dynamic ARP inspection log buffer.
Controls the type of packets that are logged per VLAN.
log
Displays the configuration and contents of the dynamic ARP
inspection log buffer.
Chapter 2
Catalyst 3550 Switch Cisco IOS Commands
OL-8566-02
Chapters
Table of Contents
