Page 1
30" Electric nstallation Ilnstruct ons Slide-In Range JSS28, JSP39 I r-?-i Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com BEFORE YOU BEGIN ANTI-TIP DEVICE -&WARNING - Toreduce therisk Read these instructions completely and carefully. of tipping, the appliance...
Installation Instructions PREPARE TO INSTALL THE RANGE • Move range indoors in front of cabinet DOOR REMOVAL (optional) opening. • Protect the kitchen floor! Flatten and place a Door removal is not a requirement piece of the shipping carton in front of the installation of the product,...
Installation Instructions MINIMUM CLEARANCES Make sure the wall coverings, countertop • The distance from the floor to the top cabinets around the cooktop can withstand of the counter must be at least 35-7/8". heat (up to 200°F) generated by the range. The maximum counter height...
#JXS32XX or a Main Top Rear Filler Kit, 30"-- Model #JXS66XX. These kits are available through your GE dealer, if the existing cutout If you have a countertop deeper than 25" is in a counter that has a backsplash (post-...
Page 5
(up to 1/4" each side), you can order a side trim extension kit, JXS86XX, through the GE service center. 25" 30" NOTE: If the distance from the back wall to the front of the counter...
Installation Instructions ELECTRICAL CONNECTIONS ELECTRICAL REQUIREMENTS TO MAKE ELECTRICAL CONNECTION CAUTION: For p ersonal safety, do not use an extension cord with this • Remove the junction block access appliance. Remove house fuse or open cover (on range back). When re-installing circuit breaker before...
Page 7
Installation Instructions _-I POWER CORD AND STRAIN _-I CONDUIT AND SQUEEZE RELIEF INSTALLATION CONNECTOR INSTALLATION • For power cord installations only (see the For conduit installations only, purchase next step if using conduit), assemble squeeze connector matching the diameter strain relief in the hole.
Page 8
Installation Instructions ELECTRICAL CONNECTIONS (CONT.) 3-WIRE POWER CORD 4-WIRE POWER CORD INSTALLATION INSTALLATION WARNING: WARNING: The neutral wire of The neutral or ground wire of the power cord must be the supply circuit must be connected connected to the neutral terminal located the neutral terminal located in the lower...
Installation Instructions 4-WIRE CONDUIT INSTALLATION 3-WIRE CONDUIT INSTALLATION Loosen the three lower terminal screws Loosen the 3 lower terminal screws from the terminal block, Insert the center bare from the terminal block. Remove wire (white/neutral) tip through the bottom ground screw and ground plate and retain...
Installation Instructions INSTALL THE RANGE ANTI-TIP DEVICE INSTALLATION SLIDE RANGE INTO OPENING An Anti-33p bracket is supplied with On models with a power cord, plug it into instructions for installation in a variety the receptacle. Locate the cord in the back locations.
Page 11
Installation Instructions _-I REPLACING THE OVEN DOOR REPLACING THE STORAGE DRAWER NOTE: The oven door is heavy. You may need help lifting the door high enough to slide Place the drawer into the hinge slots. Do not lift the door rail on the the handle.
Installation Instructions IMPORTANT INSTALLATION FINAL INSTALLATION CHECKLIST INSTRUCTIONS FOR RANGES USED WITH COUNTERTOP • Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced. HEIGHTS UP TO 38" • Be sure power is in service to the building. The height of the range must be adjusted to the •...