Step 9, Install Filters; Step 10, Finalize Installation - GE Monogram ZV750 Installation Instructions Manual
36" vent hood
Hide thumbs
Also See for Monogram ZV750:
- Installation instructions manual (56 pages) ,
- Owner's manual (32 pages) ,
- Technical service manual (30 pages)
Table of Contents
Available languages
Available languages
Instollotion
Instructions
INSTALLATION - RECIRCULATING
_-I INSTALL FILTERS
• There are two channels inside the back and front of the
hood. These channels will hold the charcoal filters and
stainless steel grease filters in place.
Upper charcoal
filter channel
Lower charcoal
filter channel
Install charcoal filters
• Remove protective
film on the chorcool
filters.
• Tip charcoal filters into the upper (top) channels at the
rear of the opening. Grasp the filter tab, lift and pull
forward
until it rests in the front upper channel.
• Install all 3 charcoal filters.
Upper charcoal
filter channel
_'--.
Grasp
tab,
lift and pull forward
Install
grease filters
• Remove protective
film from grease filters.
• Tip the grease filter into the lower channel at the rear of
the opening. Push buck, lift and pull the knob forward until
the filter rests on the channel.
• Install all 3 grease filters.
• Turn power on. If the filter light on the control panel glows,
adjust the right-side filter in the channel to engage the
switch arm.
filter slots
FINALIZE INSTALLATION
• Remove protective film covering the control panel
on the front face of the hood and ang remaining
packaging
materials.
• Make sure the filters are seated properlg when
installed and the filter light is not on.
• Be sure fan and lights operate correctlg.
Refer to
the Owner's Manual for operating
instructions
and
Problem Solver.
18
Chapters
Table of Contents
